[PATCH v11 11/12] drm/mediatek: dpi: Only enable dpi after the bridge is enabled

[Bo-Chen Chen]

From: Guillaume Ranquet <granquet at baylibre.com>

Enabling the dpi too early causes glitches on screen.

Move the call to mtk_dpi_enable() at the end of the bridge_enable
callback to ensure everything is setup properly before enabling dpi.

Signed-off-by: Guillaume Ranquet <granquet at baylibre.com>
Signed-off-by: Bo-Chen Chen <rex-bc.chen at mediatek.com>
---
 drivers/gpu/drm/mediatek/mtk_dpi.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/mediatek/mtk_dpi.c b/drivers/gpu/drm/mediatek/mtk_dpi.c
index 08c8f21b4421..9668bd5dd14a 100644
--- a/drivers/gpu/drm/mediatek/mtk_dpi.c
+++ b/drivers/gpu/drm/mediatek/mtk_dpi.c
@@ -480,7 +480,6 @@ static int mtk_dpi_power_on(struct mtk_dpi *dpi)
 	if (dpi->pinctrl && dpi->pins_dpi)
 		pinctrl_select_state(dpi->pinctrl, dpi->pins_dpi);
 
-	mtk_dpi_enable(dpi);
 	return 0;
 
 err_pixel:
@@ -726,6 +725,7 @@ static void mtk_dpi_bridge_enable(struct drm_bridge *bridge)
 
 	mtk_dpi_power_on(dpi);
 	mtk_dpi_set_display_mode(dpi, &dpi->mode);
+	mtk_dpi_enable(dpi);
 }
 
 static enum drm_mode_status
-- 
2.18.0