[PATCH v1 1/4] pinctrl: add generic driving setup property on mt8192

[Guodong Liu]

This patch provides generic driving setup, which support
2/4/6/8/10/12/14/16mA driving, original driver just set
raw data setup setting when use drive-strength property

Signed-off-by: Guodong Liu <guodong.liu at mediatek.com>
---
 drivers/pinctrl/mediatek/pinctrl-mt8192.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/mediatek/pinctrl-mt8192.c b/drivers/pinctrl/mediatek/pinctrl-mt8192.c
index acccde9262ba..9faf7001369d 100644
--- a/drivers/pinctrl/mediatek/pinctrl-mt8192.c
+++ b/drivers/pinctrl/mediatek/pinctrl-mt8192.c
@@ -1372,8 +1372,8 @@ static const struct mtk_pin_soc mt8192_data = {
 	.gpio_m = 0,
 	.bias_set_combo = mtk_pinconf_bias_set_combo,
 	.bias_get_combo = mtk_pinconf_bias_get_combo,
-	.drive_set = mtk_pinconf_drive_set_raw,
-	.drive_get = mtk_pinconf_drive_get_raw,
+	.drive_set	= mtk_pinconf_drive_set_rev1,
+	.drive_get	= mtk_pinconf_drive_get_rev1,
 	.adv_pull_get = mtk_pinconf_adv_pull_get,
 	.adv_pull_set = mtk_pinconf_adv_pull_set,
 	.adv_drive_get = mtk_pinconf_adv_drive_get,
-- 
2.25.5