[PATCH v5 0/6] Introduce PRU remoteproc consumer API

[Puranjay Mohan]

This is the v5 of the patch series [1]. The 6th patch in the series was
added in v4 and it had some checkpatch.pl errors which are removed here.

I have posted two more patch series that depend on this series, one to
the soc tree and another to the networking tree. I had sent all the 3
series, including this one as RFC [2] to get comments and to explain the
dependencies.

The Programmable Real-Time Unit and Industrial Communication Subsystem
(PRU-ICSS or simply PRUSS) on various TI SoCs consists of dual 32-bit
RISC cores (Programmable Real-Time Units, or PRUs) for program execution.

There are 3 foundation components for PRUSS subsystem: the PRUSS platform
driver, the PRUSS INTC driver and the PRUSS remoteproc driver. All were
already merged and can be found under:
1) drivers/soc/ti/pruss.c
   Documentation/devicetree/bindings/soc/ti/ti,pruss.yaml
2) drivers/irqchip/irq-pruss-intc.c
   Documentation/devicetree/bindings/interrupt-controller/ti,pruss-intc.yaml
3) drivers/remoteproc/pru_rproc.c
   Documentation/devicetree/bindings/remoteproc/ti,pru-rproc.yaml

The programmable nature of the PRUs provide flexibility to implement custom
peripheral interfaces, fast real-time responses, or specialized data handling.
Example of a PRU consumer drivers will be:
  - Software UART over PRUSS
  - PRU-ICSS Ethernet EMAC

In order to make usage of common PRU resources and allow the consumer drivers to
configure the PRU hardware for specific usage the PRU API is introduced.

[1] https://patchwork.kernel.org/project/linux-remoteproc/cover/20220603121520.13730-1-p-mohan@ti.com/
[2] https://patchwork.kernel.org/project/linux-remoteproc/cover/20220406094358.7895-1-p-mohan@ti.com/

Thanks and Regards,
Puranjay Mohan

Roger Quadros (1):
  remoteproc: pru: Add pru_rproc_set_ctable() function

Suman Anna (2):
  dt-bindings: remoteproc: Add PRU consumer bindings
  remoteproc: pru: Make sysfs entries read-only for PRU client driven
    boots

Tero Kristo (3):
  remoteproc: pru: Add APIs to get and put the PRU cores
  remoteproc: pru: Configure firmware based on client setup
  remoteproc: pru: add support for configuring GPMUX based on client
    setup

 .../bindings/remoteproc/ti,pru-consumer.yaml  |  69 +++++
 drivers/remoteproc/pru_rproc.c                | 254 +++++++++++++++++-
 include/linux/pruss.h                         |  78 ++++++
 3 files changed, 396 insertions(+), 5 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/remoteproc/ti,pru-consumer.yaml
 create mode 100644 include/linux/pruss.h

-- 
2.17.1