[PATCH 21/36] serial: stm32: Fill in rs485_supported

[Ilpo Järvinen]

Add information on supported serial_rs485 features.

Signed-off-by: Ilpo Järvinen <ilpo.jarvinen at linux.intel.com>
---
 drivers/tty/serial/stm32-usart.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index b7b44f4050d4..db3dd9731ee1 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -1375,6 +1375,13 @@ static void stm32_usart_deinit_port(struct stm32_port *stm32port)
 	clk_disable_unprepare(stm32port->clk);
 }
 
+static const struct serial_rs485 stm32_rs485_supported = {
+	.flags = SER_RS485_ENABLED | SER_RS485_RTS_ON_SEND | SER_RS485_RTS_AFTER_SEND |
+		 SER_RS485_RX_DURING_TX,
+	.delay_rts_before_send = 1,
+	.delay_rts_after_send = 1,
+};
+
 static int stm32_usart_init_port(struct stm32_port *stm32port,
 				 struct platform_device *pdev)
 {
@@ -1394,6 +1401,7 @@ static int stm32_usart_init_port(struct stm32_port *stm32port,
 	port->has_sysrq = IS_ENABLED(CONFIG_SERIAL_STM32_CONSOLE);
 	port->irq = irq;
 	port->rs485_config = stm32_usart_config_rs485;
+	port->rs485_supported = &stm32_rs485_supported;
 
 	ret = stm32_usart_init_rs485(port, pdev);
 	if (ret)
-- 
2.30.2