[PATCH v2 2/3] arm64: dts: add dts files for bcmbca SoC bcm4912

[Florian Fainelli]

On 5/31/2022 5:42 PM, William Zhang wrote:
> Add dts for ARMv8 based broadband SoC BCM4912. bcm4912.dtsi is the
> SoC description dts header and bcm94912.dts is a simple dts file for
> Broadcom BCM94912 Reference board that only enable the UART port.
> 
> Signed-off-by: William Zhang <william.zhang at broadcom.com>
> 
> ---

[snip]

> +
> +	axi at 81000000 {
> +		compatible = "simple-bus";
> +		#address-cells = <2>;
> +		#size-cells = <2>;

See comment below for the ubus node.

> +		ranges = <0x0 0x0 0x0 0x81000000 0x0 0x8000>;
> +
> +		gic: interrupt-controller at 1000 {
> +			compatible = "arm,gic-400";
> +			#interrupt-cells = <3>;
> +			interrupt-controller;
> +			interrupts = <GIC_PPI 9 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>;
> +			reg = <0x0 0x1000 0x0 0x1000>,
> +				<0x0 0x2000 0x0 0x2000>,
> +				<0x0 0x4000 0x0 0x2000>,
> +				<0x0 0x6000 0x0 0x2000>;
> +		};
> +	};
> +
> +	bus at ff800000 {
> +		compatible = "simple-bus";
> +		#address-cells = <2>;
> +		#size-cells = <2>;

This does not quite make sense, as I doubt that this part of the bus is 
64-bit capable, rather, I would expect to find both #address-cells and 
#size-cells to be set to 1 and ... (see below)

> +		ranges = <0x0 0x0 0x0 0xff800000 0x0 0x800000>;
> +
> +		uart0: serial at 12000 {
> +			compatible = "arm,pl011", "arm,primecell";
> +			reg = <0x0 0x12000 0x0 0x1000>;

... have this become simply:

			reg = <0x12000 0x1000>:

which also looks awfully big for an UART block, an entire 4KB worth of 
register space?
-- 
Florian