[PATCH] ARM: Fix typo in comment

[Slark Xiao]

Fix typo in the comment

Signed-off-by: Slark Xiao <slark_xiao at 163.com>
---
 arch/arm/Kconfig                  | 4 ++--
 arch/arm/include/asm/unwind.h     | 2 +-
 arch/arm/mach-pxa/hx4700-pcmcia.c | 2 +-
 3 files changed, 4 insertions(+), 4 deletions(-)

diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index 35ef69fc2f3f..db124fdbb996 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -1638,7 +1638,7 @@ config ARM_ATAG_DTB_COMPAT_CMDLINE_EXTEND
 	bool "Extend with bootloader kernel arguments"
 	help
 	  The command-line arguments provided by the boot loader will be
-	  appended to the the device tree bootargs property.
+	  appended to the device tree bootargs property.
 
 endchoice
 
@@ -1796,7 +1796,7 @@ config DMI
 	  continue to boot on existing non-UEFI platforms.
 
 	  NOTE: This does *NOT* enable or encourage the use of DMI quirks,
-	  i.e., the the practice of identifying the platform via DMI to
+	  i.e., the practice of identifying the platform via DMI to
 	  decide whether certain workarounds for buggy hardware and/or
 	  firmware need to be enabled. This would require the DMI subsystem
 	  to be enabled much earlier than we do on ARM, which is non-trivial.
diff --git a/arch/arm/include/asm/unwind.h b/arch/arm/include/asm/unwind.h
index b51f85417f58..5fc323586c7a 100644
--- a/arch/arm/include/asm/unwind.h
+++ b/arch/arm/include/asm/unwind.h
@@ -10,7 +10,7 @@
 
 #ifndef __ASSEMBLY__
 
-/* Unwind reason code according the the ARM EABI documents */
+/* Unwind reason code according the ARM EABI documents */
 enum unwind_reason_code {
 	URC_OK = 0,			/* operation completed successfully */
 	URC_CONTINUE_UNWIND = 8,
diff --git a/arch/arm/mach-pxa/hx4700-pcmcia.c b/arch/arm/mach-pxa/hx4700-pcmcia.c
index e2331dfe427d..860b78aed18c 100644
--- a/arch/arm/mach-pxa/hx4700-pcmcia.c
+++ b/arch/arm/mach-pxa/hx4700-pcmcia.c
@@ -30,7 +30,7 @@ static int hx4700_pcmcia_hw_init(struct soc_pcmcia_socket *skt)
 	/*
 	 * IRQ type must be set before soc_pcmcia_hw_init() calls request_irq().
 	 * The asic3 default IRQ type is level trigger low level detect, exactly
-	 * the the signal present on GPIOD4_CF_nCD when a CF card is inserted.
+	 * the signal present on GPIOD4_CF_nCD when a CF card is inserted.
 	 * If the IRQ type is not changed, the asic3 interrupt handler will loop
 	 * repeatedly because it is unable to clear the level trigger interrupt.
 	 */
-- 
2.25.1