[PATCH v10 0/3] arm64: mvebu: Support for Marvell 98DX2530 (and variants)

[Gregory CLEMENT]

Vadym Kochan <vadym.kochan at plvision.eu> writes:

> This series adds support for the Marvell 98DX2530 SoC which is the Control and
> Management CPU integrated into the AlleyCat5/AlleyCat5X series of Marvell
> switches.
>
> The CPU core is an ARM Cortex-A55 with neon, simd and crypto extensions.
>
> This is fairly similar to the Armada-3700 SoC so most of the required
> peripherals are already supported. This series adds a devicetree and pinctrl
> driver for the SoC and the RD-AC5X-32G16HVG6HLG reference board.
>
> The pinctrl changes from v4 have been picked up and are in linux-next so I
> haven't included them in this round. That leaves just the dts files and a minor
> Kconfig update for arm64.
>
> Changes:
>
> v10:
>       1) Use different cnm clock for AC5 and AC5X DTSIs
>
>       2) Rename device-tree yaml binding to match the $id
>
> v9 (proposed by Marvell):
>    It was discussed with Chris that Marvell will add some changes:
>       1) Rename "armada-" prefix in dts(i) file names to ac5, because
>          Armada has not much common with AC5 SoC.
>
>       2) Add clock fixes:
>          a) rename core_clock to cnm_clock
>
>          b) remove axi_clock
>
>          c) change cnm_clock to 325MHZ
>
>          d) use cnm_clock for the UART
>
> Chris Packham (3):
>   dt-bindings: marvell: Document the AC5/AC5X compatibles
>   arm64: dts: marvell: Add Armada 98DX2530 SoC and RD-AC5X board
>   arm64: marvell: enable the 98DX2530 pinctrl driver
>
>  .../bindings/arm/marvell/marvell,ac5.yaml     |  32 ++
>  arch/arm64/Kconfig.platforms                  |   2 +
>  arch/arm64/boot/dts/marvell/Makefile          |   1 +
>  arch/arm64/boot/dts/marvell/ac5-98dx25xx.dtsi | 291 ++++++++++++++++++
>  .../boot/dts/marvell/ac5-98dx35xx-rd.dts      | 101 ++++++
>  arch/arm64/boot/dts/marvell/ac5-98dx35xx.dtsi |  17 +
>  6 files changed, 444 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/arm/marvell/marvell,ac5.yaml
>  create mode 100644 arch/arm64/boot/dts/marvell/ac5-98dx25xx.dtsi
>  create mode 100644 arch/arm64/boot/dts/marvell/ac5-98dx35xx-rd.dts
>  create mode 100644 arch/arm64/boot/dts/marvell/ac5-98dx35xx.dtsi
>


Series applied on mvebu/dt64

Thanks,

Gregory


> -- 
> 2.17.1
>

-- 
Gregory Clement, Bootlin
Embedded Linux and Kernel engineering
http://bootlin.com