[PATCH net-next v3 10/47] net: phylink: Adjust link settings based on rate adaptation

[Andrew Lunn]

On Fri, Jul 15, 2022 at 05:59:17PM -0400, Sean Anderson wrote:
> If the phy is configured to use pause-based rate adaptation, ensure that
> the link is full duplex with pause frame reception enabled. Note that these
> settings may be overridden by ethtool.
> 
> Signed-off-by: Sean Anderson <sean.anderson at seco.com>
> ---
> 
> Changes in v3:
> - New
> 
>  drivers/net/phy/phylink.c | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c
> index 7fa21941878e..7f65413aa778 100644
> --- a/drivers/net/phy/phylink.c
> +++ b/drivers/net/phy/phylink.c
> @@ -1445,6 +1445,10 @@ static void phylink_phy_change(struct phy_device *phydev, bool up)
>  	pl->phy_state.speed = phy_interface_speed(phydev->interface,
>  						  phydev->speed);
>  	pl->phy_state.duplex = phydev->duplex;
> +	if (phydev->rate_adaptation == RATE_ADAPT_PAUSE) {
> +		pl->phy_state.duplex = DUPLEX_FULL;
> +		rx_pause = true;
> +	}

I would not do this. If the requirements for rate adaptation are not
fulfilled, you should turn off rate adaptation.

A MAC which knows rate adaptation is going on can help out, by not
advertising 10Half, 100Half etc. Autoneg will then fail for modes
where rate adaptation does not work.

The MAC should also be declaring what sort of pause it supports, so
disable rate adaptation if it does not have async pause.

      Andrew