[PATCH 0/6] arm64: dts: imx8mm-kontron: Improvements and OSM board support

[Frieder Schrempf]

From: Frieder Schrempf <frieder.schrempf at kontron.de>

This set contains a few small improvements for the imx8mm-kontron devicetrees
(patch 1 to 4) and support for a new SoM (patch 5-6, including baseboard) that
complies to the Open Standard Module (OSM) 1.0 hardware specification, size S
(https://sget.org/standards/osm).

Frieder Schrempf (6):
  arm64: dts: imx8mm-kontron: Adjust board and SoM model strings
  arm64: dts: imx8mm-kontron: Use the VSELECT signal to switch SD card
    IO voltage
  arm64: dts: imx8mm-kontron: Remove low DDRC operating point
  arm64: dts: imx8mm-kontron: Use upper case PMIC regulator names
  arm64: dts: Add support for Kontron SL/BL i.MX8MM OSM-S
  dt-bindings: arm: fsl: Add Kontron BL i.MX8MM OSM-S board

 .../devicetree/bindings/arm/fsl.yaml          |   6 +
 arch/arm64/boot/dts/freescale/Makefile        |   1 +
 .../dts/freescale/imx8mm-kontron-n801x-s.dts  |   5 +-
 .../freescale/imx8mm-kontron-n801x-som.dtsi   |  30 +-
 .../dts/freescale/imx8mm-kontron-n802x-s.dts  | 377 ++++++++++++++++++
 .../freescale/imx8mm-kontron-n802x-som.dtsi   | 309 ++++++++++++++
 6 files changed, 709 insertions(+), 19 deletions(-)
 create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-kontron-n802x-s.dts
 create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-kontron-n802x-som.dtsi

-- 
2.37.0