[PATCH v4 1/8] serial: ar933x: Fix check for RS485 support

[Lino Sanfilippo]

From: Lino Sanfilippo <l.sanfilippo at kunbus.com>

RS485 is not possible without an RTS GPIO regardless of whether RS485 is
enabled at boot time or not. So correct the concerning check in the probe()
function.

Fixes: e849145e1fdd ("serial: ar933x: Fill in rs485_supported")
Signed-off-by: Lino Sanfilippo <l.sanfilippo at kunbus.com>
---
 drivers/tty/serial/ar933x_uart.c | 9 +++++----
 1 file changed, 5 insertions(+), 4 deletions(-)

diff --git a/drivers/tty/serial/ar933x_uart.c b/drivers/tty/serial/ar933x_uart.c
index f931ecbc0bc0..f7b4638d69e5 100644
--- a/drivers/tty/serial/ar933x_uart.c
+++ b/drivers/tty/serial/ar933x_uart.c
@@ -798,11 +798,12 @@ static int ar933x_uart_probe(struct platform_device *pdev)
 
 	up->rts_gpiod = mctrl_gpio_to_gpiod(up->gpios, UART_GPIO_RTS);
 
-	if ((port->rs485.flags & SER_RS485_ENABLED) &&
-	    !up->rts_gpiod) {
-		dev_err(&pdev->dev, "lacking rts-gpio, disabling RS485\n");
-		port->rs485.flags &= ~SER_RS485_ENABLED;
+	if (!up->rts_gpiod) {
 		port->rs485_supported = ar933x_no_rs485;
+		if (port->rs485.flags & SER_RS485_ENABLED) {
+			dev_err(&pdev->dev, "lacking rts-gpio, disabling RS485\n");
+			port->rs485.flags &= ~SER_RS485_ENABLED;
+		}
 	}
 
 #ifdef CONFIG_SERIAL_AR933X_CONSOLE
-- 
2.25.1