[PATCH v4 2/4] dt-bindings: usb: dwc3-imx8mp: Add imx8mp specific flags

[Rob Herring]

On Wed, 26 Jan 2022 15:13:38 +0100, Alexander Stein wrote:
> This adds bindings for features in the USB glue block. They allow
> setting polarity of PWR and OC as well as disabling port power control.
> Also permanently attached can be annotated as well.
> Additional IO address and clock are needed.
> 
> Signed-off-by: Alexander Stein <alexander.stein at ew.tq-group.com>
> ---
>  .../bindings/usb/fsl,imx8mp-dwc3.yaml         | 31 ++++++++++++++++---
>  1 file changed, 27 insertions(+), 4 deletions(-)
> 

Running 'make dtbs_check' with the schema in this patch gives the
following warnings. Consider if they are expected or the schema is
incorrect. These may not be new warnings.

Note that it is not yet a requirement to have 0 warnings for dtbs_check.
This will change in the future.

Full log is available here: https://patchwork.ozlabs.org/patch/1584490


usb at 32f10100: reg: [[854655232, 8]] is too short
	arch/arm64/boot/dts/freescale/imx8mp-evk.dt.yaml
	arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dt.yaml

usb at 32f10108: reg: [[854655240, 8]] is too short
	arch/arm64/boot/dts/freescale/imx8mp-evk.dt.yaml
	arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dt.yaml