[PATCH v2 0/3] add support for Allwinner R40 CAN controller

[Evgeny Boger]

Allwinner R40 (also known as A40i, T3, V40) has a CAN controller. The
controller is the same as in earlier A10 and A20 SoCs, but needs reset
line to be deasserted before use.

This patch series introduce new compatible for R40 CAN controller,
add support for reset line in driver and add the corresponding nodes
to the SoC .dtsi file.

The CAN IP was documented in early V40 datasheet [1]. It also fully
supported in vendor BSP. However, CAN description was removed from
more recent A40i, T3 and R40 user manuals and datasheets.
Anyway, we verified that the CAN controller is indeed there and tested
it extensively on A40i-based custom hardware [2].

[1] https://linux-sunxi.org/File:Allwinner_V40_Datasheet_V1.0.pdf
[2] https://wirenboard.com/en/product/wiren-board-7/

Changes in v2:
  - sort pinmux nodes alphabetically and mark them with omit-if-no-ref

Evgeny Boger (3):
  dt-bindings: net: can: add support for Allwinner R40 CAN controller
  can: sun4i_can: add support for R40 CAN controller
  ARM: dts: sun8i: r40: add node for CAN controller

 .../net/can/allwinner,sun4i-a10-can.yaml      | 24 ++++++++
 arch/arm/boot/dts/sun8i-r40.dtsi              | 21 +++++++
 drivers/net/can/sun4i_can.c                   | 61 ++++++++++++++++++-
 3 files changed, 105 insertions(+), 1 deletion(-)

-- 
2.25.1