[PATCH 7/7] clocksource/drivers/timer-microchip-pit64b: use mchp_pit64b_{suspend, resume}

[Claudiu Beznea]

Use mchp_pit64b_suspend() and mchp_pit64b_resume() to disable or
enable timers clocks on init and remove specific
clk_prepare_{disable, enable} calls. This is ok also for clockevent timer
as proper clock enable, disable is done on .set_state_oneshot,
.set_state_periodic, .set_state_shutdown calls.

Signed-off-by: Claudiu Beznea <claudiu.beznea at microchip.com>
---
 drivers/clocksource/timer-microchip-pit64b.c | 17 ++++-------------
 1 file changed, 4 insertions(+), 13 deletions(-)

diff --git a/drivers/clocksource/timer-microchip-pit64b.c b/drivers/clocksource/timer-microchip-pit64b.c
index dd1661604966..0f0d8160660c 100644
--- a/drivers/clocksource/timer-microchip-pit64b.c
+++ b/drivers/clocksource/timer-microchip-pit64b.c
@@ -352,6 +352,7 @@ static int __init mchp_pit64b_init_clksrc(struct mchp_pit64b_timer *timer,
 	if (!cs)
 		return -ENOMEM;
 
+	mchp_pit64b_resume(timer);
 	mchp_pit64b_reset(timer, ULLONG_MAX, MCHP_PIT64B_MR_CONT, 0);
 
 	mchp_pit64b_cs_base = timer->base;
@@ -373,8 +374,7 @@ static int __init mchp_pit64b_init_clksrc(struct mchp_pit64b_timer *timer,
 		pr_debug("clksrc: Failed to register PIT64B clocksource!\n");
 
 		/* Stop timer. */
-		writel_relaxed(MCHP_PIT64B_CR_SWRST,
-			       timer->base + MCHP_PIT64B_CR);
+		mchp_pit64b_suspend(timer);
 		kfree(cs);
 
 		return ret;
@@ -462,19 +462,10 @@ static int __init mchp_pit64b_dt_init_timer(struct device_node *node,
 	if (ret)
 		goto irq_unmap;
 
-	ret = clk_prepare_enable(timer.pclk);
-	if (ret)
-		goto irq_unmap;
-
-	if (timer.mode & MCHP_PIT64B_MR_SGCLK) {
-		ret = clk_prepare_enable(timer.gclk);
-		if (ret)
-			goto pclk_unprepare;
-
+	if (timer.mode & MCHP_PIT64B_MR_SGCLK)
 		clk_rate = clk_get_rate(timer.gclk);
-	} else {
+	else
 		clk_rate = clk_get_rate(timer.pclk);
-	}
 	clk_rate = clk_rate / (MCHP_PIT64B_MODE_TO_PRES(timer.mode) + 1);
 
 	if (clkevt)
-- 
2.32.0