[PATCH v7 8/8] PCI: imx6: Add the compliance tests mode support

[Bjorn Helgaas]

In subject:

s/Add the/Add/

On Wed, Feb 16, 2022 at 02:21:03PM +0800, Richard Zhu wrote:
> Refer to the system board signal Quality of PCIe archiecture PHY test
> specification. Signal quality tests(for example: jitters,  differential
> eye opening and so on ) can be executed with devices in the
> polling.compliance state.

s/archiecture/architecture/
s/tests(for/tests (for/
s/jitters,  /jitter, /              (remove double space)
s/so on )/so on)/

Is this a reference to a spec?  If so, I can't tell the name of the
spec, the revision, or the section number.

> To let the device support polling.compliance stat, the clocks and powers
> shouldn't be turned off when the probe of device driver is failed.

s/stat/state/
s/powers/power/
s/driver is failed/driver fails/

> Based on CLB(Compliance Load Board) Test Fixture and so on test
> equipments, the PHY link would be down during the compliance tests.
> Refer to this scenario, add the i.MX PCIe compliance tests mode enable
> support, and keep the clocks and powers on, and finish the driver probe
> without error return.

s/CLB(Compliance/CLB (Compliance/

> Use the "pci_imx6.compliance=1" in kernel command line to enable the
> compliance tests mode.

Thanks for including this in the commit log!

>  	ret = dw_pcie_host_init(&pci->pp);
> -	if (ret < 0)
> +	if (ret < 0) {
> +		if (imx6_pcie_cmp_mode) {
> +			dev_info(dev, "Driver loaded with compliance test mode enabled.\n");

To match other messages:

s/Driver loaded/driver loaded/
s/enabled./enabled/

> +			ret = 0;
> +		} else {
> +			dev_err(dev, "Unable to add pcie port.\n");

s/Unable/unable/
s/pcie/PCIe/
s/port./port/

> +		}
>  		return ret;
> +	}
>  
>  	if (pci_msi_enabled()) {
>  		u8 offset = dw_pcie_find_capability(pci, PCI_CAP_ID_MSI);
> -- 
> 2.25.1
>