[PATCH RFC net-next v2 07/10] net: dsa: mt7530: switch to use phylink_get_linkmodes()

[Russell King (Oracle)]

Switch mt7530 to use phylink_get_linkmodes() to generate the ethtool
linkmodes that can be supported. We are unable to use the generic
helper for this as pause modes are dependent on the interface as
the Autoneg bit depends on the interface mode.

Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/dsa/mt7530.c | 58 ++++------------------------------------
 1 file changed, 5 insertions(+), 53 deletions(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index db1d13718ff1..8e96bcd44cbb 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -2516,20 +2516,6 @@ static int mt7531_rgmii_setup(struct mt7530_priv *priv, u32 port,
 	return 0;
 }
 
-static void mt7531_sgmii_validate(struct mt7530_priv *priv, int port,
-				  phy_interface_t interface,
-				  unsigned long *supported)
-{
-	/* Port5 supports ethier RGMII or SGMII.
-	 * Port6 supports SGMII only.
-	 */
-	if ((port == 5 || port == 6) &&
-	    interface == PHY_INTERFACE_MODE_2500BASEX) {
-		phylink_set(supported, 2500baseX_Full);
-		phylink_set(supported, 2500baseT_Full);
-	}
-}
-
 static void
 mt7531_sgmii_link_up_force(struct dsa_switch *ds, int port,
 			   unsigned int mode, phy_interface_t interface,
@@ -2897,52 +2883,22 @@ static void mt753x_phylink_get_caps(struct dsa_switch *ds, int port,
 	priv->info->mac_port_get_caps(ds, port, config);
 }
 
-static void
-mt7530_mac_port_validate(struct dsa_switch *ds, int port,
-			 phy_interface_t interface,
-			 unsigned long *supported)
-{
-}
-
-static void mt7531_mac_port_validate(struct dsa_switch *ds, int port,
-				     phy_interface_t interface,
-				     unsigned long *supported)
-{
-	struct mt7530_priv *priv = ds->priv;
-
-	mt7531_sgmii_validate(priv, port, interface, supported);
-}
-
 static void
 mt753x_phylink_validate(struct dsa_switch *ds, int port,
 			unsigned long *supported,
 			struct phylink_link_state *state)
 {
 	__ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
-	struct mt7530_priv *priv = ds->priv;
+	u32 caps;
+
+	caps = dsa_to_port(ds, port)->pl_config.mac_capabilities;
 
 	phylink_set_port_modes(mask);
+	phylink_get_linkmodes(mask, state->interface, caps);
 
 	if (state->interface != PHY_INTERFACE_MODE_TRGMII &&
-	    !phy_interface_mode_is_8023z(state->interface)) {
-		phylink_set(mask, 10baseT_Half);
-		phylink_set(mask, 10baseT_Full);
-		phylink_set(mask, 100baseT_Half);
-		phylink_set(mask, 100baseT_Full);
+	    !phy_interface_mode_is_8023z(state->interface))
 		phylink_set(mask, Autoneg);
-	}
-
-	/* This switch only supports 1G full-duplex. */
-	if (state->interface != PHY_INTERFACE_MODE_MII &&
-	    state->interface != PHY_INTERFACE_MODE_2500BASEX)
-		phylink_set(mask, 1000baseT_Full);
-		phylink_set(mask, 1000baseX_Full);
-	}
-
-	priv->info->mac_port_validate(ds, port, state->interface, mask);
-
-	phylink_set(mask, Pause);
-	phylink_set(mask, Asym_Pause);
 
 	linkmode_and(supported, supported, mask);
 	linkmode_and(state->advertising, state->advertising, mask);
@@ -3143,7 +3099,6 @@ static const struct mt753x_info mt753x_table[] = {
 		.phy_write = mt7530_phy_write,
 		.pad_setup = mt7530_pad_clk_setup,
 		.mac_port_get_caps = mt7530_mac_port_get_caps,
-		.mac_port_validate = mt7530_mac_port_validate,
 		.mac_port_get_state = mt7530_phylink_mac_link_state,
 		.mac_port_config = mt7530_mac_config,
 	},
@@ -3154,7 +3109,6 @@ static const struct mt753x_info mt753x_table[] = {
 		.phy_write = mt7530_phy_write,
 		.pad_setup = mt7530_pad_clk_setup,
 		.mac_port_get_caps = mt7530_mac_port_get_caps,
-		.mac_port_validate = mt7530_mac_port_validate,
 		.mac_port_get_state = mt7530_phylink_mac_link_state,
 		.mac_port_config = mt7530_mac_config,
 	},
@@ -3166,7 +3120,6 @@ static const struct mt753x_info mt753x_table[] = {
 		.pad_setup = mt7531_pad_setup,
 		.cpu_port_config = mt7531_cpu_port_config,
 		.mac_port_get_caps = mt7531_mac_port_get_caps,
-		.mac_port_validate = mt7531_mac_port_validate,
 		.mac_port_get_state = mt7531_phylink_mac_link_state,
 		.mac_port_config = mt7531_mac_config,
 		.mac_pcs_an_restart = mt7531_sgmii_restart_an,
@@ -3228,7 +3181,6 @@ mt7530_probe(struct mdio_device *mdiodev)
 	if (!priv->info->sw_setup || !priv->info->pad_setup ||
 	    !priv->info->phy_read || !priv->info->phy_write ||
 	    !priv->info->mac_port_get_caps ||
-	    !priv->info->mac_port_validate ||
 	    !priv->info->mac_port_get_state || !priv->info->mac_port_config)
 		return -EINVAL;
 
-- 
2.30.2