[PATCH 5/6] PCI: mvebu: Add support for sending Set_Slot_Power_Limit message
Pali Rohár
pali at kernel.org
Tue Feb 22 08:31:57 PST 2022
This PCIe message is sent automatically by mvebu HW when link changes
status from down to up.
Slot power limit is read from DT property 'slot-power-limit-milliwatt' and
set to mvebu HW. When this DT property is not specified then driver treat
it as "Slot Capabilities register has not yet been initialized".
Signed-off-by: Pali Rohár <pali at kernel.org>
---
drivers/pci/controller/pci-mvebu.c | 85 ++++++++++++++++++++++++++++--
1 file changed, 80 insertions(+), 5 deletions(-)
diff --git a/drivers/pci/controller/pci-mvebu.c b/drivers/pci/controller/pci-mvebu.c
index a75d2b9196f9..c786feec4d17 100644
--- a/drivers/pci/controller/pci-mvebu.c
+++ b/drivers/pci/controller/pci-mvebu.c
@@ -66,6 +66,12 @@
#define PCIE_STAT_BUS 0xff00
#define PCIE_STAT_DEV 0x1f0000
#define PCIE_STAT_LINK_DOWN BIT(0)
+#define PCIE_SSPL_OFF 0x1a0c
+#define PCIE_SSPL_VALUE_SHIFT 0
+#define PCIE_SSPL_VALUE_MASK GENMASK(7, 0)
+#define PCIE_SSPL_SCALE_SHIFT 8
+#define PCIE_SSPL_SCALE_MASK GENMASK(9, 8)
+#define PCIE_SSPL_ENABLE BIT(16)
#define PCIE_RC_RTSTA 0x1a14
#define PCIE_DEBUG_CTRL 0x1a60
#define PCIE_DEBUG_SOFT_RESET BIT(20)
@@ -111,6 +117,8 @@ struct mvebu_pcie_port {
struct mvebu_pcie_window iowin;
u32 saved_pcie_stat;
struct resource regs;
+ u8 slot_power_limit_value;
+ u8 slot_power_limit_scale;
struct irq_domain *intx_irq_domain;
raw_spinlock_t irq_lock;
int intx_irq;
@@ -239,7 +247,7 @@ static void mvebu_pcie_setup_wins(struct mvebu_pcie_port *port)
static void mvebu_pcie_setup_hw(struct mvebu_pcie_port *port)
{
- u32 ctrl, lnkcap, cmd, dev_rev, unmask;
+ u32 ctrl, lnkcap, cmd, dev_rev, unmask, sspl;
/* Setup PCIe controller to Root Complex mode. */
ctrl = mvebu_readl(port, PCIE_CTRL_OFF);
@@ -292,6 +300,20 @@ static void mvebu_pcie_setup_hw(struct mvebu_pcie_port *port)
/* Point PCIe unit MBUS decode windows to DRAM space. */
mvebu_pcie_setup_wins(port);
+ /*
+ * Program Root Complex to automatically sends Set Slot Power Limit
+ * PCIe Message when changing status from Dl-Down to Dl-Up and valid
+ * slot power limit was specified.
+ */
+ sspl = mvebu_readl(port, PCIE_SSPL_OFF);
+ sspl &= ~(PCIE_SSPL_VALUE_MASK | PCIE_SSPL_SCALE_MASK | PCIE_SSPL_ENABLE);
+ if (port->slot_power_limit_value && port->slot_power_limit_scale) {
+ sspl |= port->slot_power_limit_value << PCIE_SSPL_VALUE_SHIFT;
+ sspl |= port->slot_power_limit_scale << PCIE_SSPL_SCALE_SHIFT;
+ sspl |= PCIE_SSPL_ENABLE;
+ }
+ mvebu_writel(port, sspl, PCIE_SSPL_OFF);
+
/* Mask all interrupt sources. */
mvebu_writel(port, ~PCIE_INT_ALL_MASK, PCIE_INT_UNMASK_OFF);
@@ -628,9 +650,16 @@ mvebu_pci_bridge_emul_pcie_conf_read(struct pci_bridge_emul *bridge,
(PCI_EXP_LNKSTA_DLLLA << 16) : 0);
break;
- case PCI_EXP_SLTCTL:
- *value = PCI_EXP_SLTSTA_PDS << 16;
+ case PCI_EXP_SLTCTL: {
+ u16 slotsta = le16_to_cpu(bridge->pcie_conf.slotsta);
+ u32 val = 0;
+ if (!(mvebu_readl(port, PCIE_SSPL_OFF) & PCIE_SSPL_ENABLE))
+ val |= PCI_EXP_SLTCTL_ASPL_DISABLE;
+ /* PCI_EXP_SLTCTL is 32-bit and contains also slot status bits */
+ val |= slotsta << 16;
+ *value = val;
break;
+ }
case PCI_EXP_RTSTA:
*value = mvebu_readl(port, PCIE_RC_RTSTA);
@@ -774,6 +803,19 @@ mvebu_pci_bridge_emul_pcie_conf_write(struct pci_bridge_emul *bridge,
mvebu_writel(port, new, PCIE_CAP_PCIEXP + PCI_EXP_LNKCTL);
break;
+ case PCI_EXP_SLTCTL:
+ if ((mask & PCI_EXP_SLTCTL_ASPL_DISABLE) &&
+ port->slot_power_limit_value &&
+ port->slot_power_limit_scale) {
+ u32 sspl = mvebu_readl(port, PCIE_SSPL_OFF);
+ if (new & PCI_EXP_SLTCTL_ASPL_DISABLE)
+ sspl &= ~PCIE_SSPL_ENABLE;
+ else
+ sspl |= PCIE_SSPL_ENABLE;
+ mvebu_writel(port, sspl, PCIE_SSPL_OFF);
+ }
+ break;
+
case PCI_EXP_RTSTA:
/*
* PME Status bit in Root Status Register (PCIE_RC_RTSTA)
@@ -868,8 +910,26 @@ static int mvebu_pci_bridge_emul_init(struct mvebu_pcie_port *port)
/*
* Older mvebu hardware provides PCIe Capability structure only in
* version 1. New hardware provides it in version 2.
+ * Enable slot support which is emulated.
*/
- bridge->pcie_conf.cap = cpu_to_le16(pcie_cap_ver);
+ bridge->pcie_conf.cap = cpu_to_le16(pcie_cap_ver | PCI_EXP_FLAGS_SLOT);
+
+ /*
+ * Set Presence Detect State bit permanently as there is no support for
+ * unplugging PCIe card from the slot. Assume that PCIe card is always
+ * connected in slot.
+ *
+ * Set physical slot number to port+1 as mvebu ports are indexed from
+ * zero and zero value is reserved for ports within the same silicon
+ * as Root Port which is not mvebu case.
+ *
+ * Also set correct slot power limit.
+ */
+ bridge->pcie_conf.slotcap = cpu_to_le32(
+ (port->slot_power_limit_value << PCI_EXP_SLTCAP_SPLV_SHIFT) |
+ (port->slot_power_limit_scale << PCI_EXP_SLTCAP_SPLS_SHIFT) |
+ ((port->port+1) << PCI_EXP_SLTCAP_PSN_SHIFT));
+ bridge->pcie_conf.slotsta = cpu_to_le16(PCI_EXP_SLTSTA_PDS);
bridge->subsystem_vendor_id = ssdev_id & 0xffff;
bridge->subsystem_id = ssdev_id >> 16;
@@ -1191,6 +1251,7 @@ static int mvebu_pcie_parse_port(struct mvebu_pcie *pcie,
{
struct device *dev = &pcie->pdev->dev;
enum of_gpio_flags flags;
+ u32 slot_power_limit;
int reset_gpio, ret;
u32 num_lanes;
@@ -1291,6 +1352,15 @@ static int mvebu_pcie_parse_port(struct mvebu_pcie *pcie,
port->reset_gpio = gpio_to_desc(reset_gpio);
}
+ slot_power_limit = of_pci_get_slot_power_limit(child,
+ &port->slot_power_limit_value,
+ &port->slot_power_limit_scale);
+ if (slot_power_limit)
+ dev_info(dev, "%s: Slot power limit %u.%uW\n",
+ port->name,
+ slot_power_limit / 1000,
+ (slot_power_limit / 100) % 10);
+
port->clk = of_clk_get_by_name(child, NULL);
if (IS_ERR(port->clk)) {
dev_err(dev, "%s: cannot get clock\n", port->name);
@@ -1587,7 +1657,7 @@ static int mvebu_pcie_remove(struct platform_device *pdev)
{
struct mvebu_pcie *pcie = platform_get_drvdata(pdev);
struct pci_host_bridge *bridge = pci_host_bridge_from_priv(pcie);
- u32 cmd;
+ u32 cmd, sspl;
int i;
/* Remove PCI bus with all devices. */
@@ -1624,6 +1694,11 @@ static int mvebu_pcie_remove(struct platform_device *pdev)
/* Free config space for emulated root bridge. */
pci_bridge_emul_cleanup(&port->bridge);
+ /* Disable sending Set Slot Power Limit PCIe Message. */
+ sspl = mvebu_readl(port, PCIE_SSPL_OFF);
+ sspl &= ~(PCIE_SSPL_VALUE_MASK | PCIE_SSPL_SCALE_MASK | PCIE_SSPL_ENABLE);
+ mvebu_writel(port, sspl, PCIE_SSPL_OFF);
+
/* Disable and clear BARs and windows. */
mvebu_pcie_disable_wins(port);
--
2.20.1
More information about the linux-arm-kernel
mailing list