[PATCH v4 05/12] PCI: mvebu: Correctly configure x1/x4 mode
Pali Rohár
pali at kernel.org
Tue Feb 22 07:50:23 PST 2022
If x1/x4 mode is not set correctly then link with endpoint card is not
established.
Use DTS property 'num-lanes' to deteriminate x1/x4 mode.
Signed-off-by: Pali Rohár <pali at kernel.org>
---
drivers/pci/controller/pci-mvebu.c | 19 ++++++++++++++++++-
1 file changed, 18 insertions(+), 1 deletion(-)
diff --git a/drivers/pci/controller/pci-mvebu.c b/drivers/pci/controller/pci-mvebu.c
index 357f0f41f68e..d0a75c3b78c3 100644
--- a/drivers/pci/controller/pci-mvebu.c
+++ b/drivers/pci/controller/pci-mvebu.c
@@ -93,6 +93,7 @@ struct mvebu_pcie_port {
void __iomem *base;
u32 port;
u32 lane;
+ bool is_x4;
int devfn;
unsigned int mem_target;
unsigned int mem_attr;
@@ -233,13 +234,25 @@ static void mvebu_pcie_setup_wins(struct mvebu_pcie_port *port)
static void mvebu_pcie_setup_hw(struct mvebu_pcie_port *port)
{
- u32 ctrl, cmd, dev_rev, mask;
+ u32 ctrl, lnkcap, cmd, dev_rev, mask;
/* Setup PCIe controller to Root Complex mode. */
ctrl = mvebu_readl(port, PCIE_CTRL_OFF);
ctrl |= PCIE_CTRL_RC_MODE;
mvebu_writel(port, ctrl, PCIE_CTRL_OFF);
+ /*
+ * Set Maximum Link Width to X1 or X4 in Root Port's PCIe Link
+ * Capability register. This register is defined by PCIe specification
+ * as read-only but this mvebu controller has it as read-write and must
+ * be set to number of SerDes PCIe lanes (1 or 4). If this register is
+ * not set correctly then link with endpoint card is not established.
+ */
+ lnkcap = mvebu_readl(port, PCIE_CAP_PCIEXP + PCI_EXP_LNKCAP);
+ lnkcap &= ~PCI_EXP_LNKCAP_MLW;
+ lnkcap |= (port->is_x4 ? 4 : 1) << 4;
+ mvebu_writel(port, lnkcap, PCIE_CAP_PCIEXP + PCI_EXP_LNKCAP);
+
/* Disable Root Bridge I/O space, memory space and bus mastering. */
cmd = mvebu_readl(port, PCIE_CMD_OFF);
cmd &= ~(PCI_COMMAND_IO | PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER);
@@ -982,6 +995,7 @@ static int mvebu_pcie_parse_port(struct mvebu_pcie *pcie,
struct device *dev = &pcie->pdev->dev;
enum of_gpio_flags flags;
int reset_gpio, ret;
+ u32 num_lanes;
port->pcie = pcie;
@@ -994,6 +1008,9 @@ static int mvebu_pcie_parse_port(struct mvebu_pcie *pcie,
if (of_property_read_u32(child, "marvell,pcie-lane", &port->lane))
port->lane = 0;
+ if (!of_property_read_u32(child, "num-lanes", &num_lanes) && num_lanes == 4)
+ port->is_x4 = true;
+
port->name = devm_kasprintf(dev, GFP_KERNEL, "pcie%d.%d", port->port,
port->lane);
if (!port->name) {
--
2.20.1
More information about the linux-arm-kernel
mailing list