[PATCH v2 10/22] drm/exynos: plane: Remove redundant zpos initialisation

[Maxime Ripard]

The exynos KMS driver will call drm_plane_create_zpos_property() with an
init value depending on the plane purpose.

Since the initial value wasn't carried over in the state, the driver had
to set it again in exynos_drm_plane_reset(). However, the helpers have
been adjusted to set it properly at reset, so this is not needed
anymore.

Cc: linux-arm-kernel at lists.infradead.org
Cc: linux-samsung-soc at vger.kernel.org
Cc: Alim Akhtar <alim.akhtar at samsung.com>
Cc: Inki Dae <inki.dae at samsung.com>
Cc: Joonyoung Shim <jy0922.shim at samsung.com>
Cc: Krzysztof Kozlowski <krzysztof.kozlowski at canonical.com>
Cc: Kyungmin Park <kyungmin.park at samsung.com>
Cc: Seung-Woo Kim <sw0312.kim at samsung.com>
Signed-off-by: Maxime Ripard <maxime at cerno.tech>
---
 drivers/gpu/drm/exynos/exynos_drm_plane.c | 5 +----
 1 file changed, 1 insertion(+), 4 deletions(-)

diff --git a/drivers/gpu/drm/exynos/exynos_drm_plane.c b/drivers/gpu/drm/exynos/exynos_drm_plane.c
index df76bdee7dca..3615cf329e32 100644
--- a/drivers/gpu/drm/exynos/exynos_drm_plane.c
+++ b/drivers/gpu/drm/exynos/exynos_drm_plane.c
@@ -122,7 +122,6 @@ static void exynos_plane_mode_set(struct exynos_drm_plane_state *exynos_state)
 
 static void exynos_drm_plane_reset(struct drm_plane *plane)
 {
-	struct exynos_drm_plane *exynos_plane = to_exynos_plane(plane);
 	struct exynos_drm_plane_state *exynos_state;
 
 	if (plane->state) {
@@ -133,10 +132,8 @@ static void exynos_drm_plane_reset(struct drm_plane *plane)
 	}
 
 	exynos_state = kzalloc(sizeof(*exynos_state), GFP_KERNEL);
-	if (exynos_state) {
+	if (exynos_state)
 		__drm_atomic_helper_plane_reset(plane, &exynos_state->base);
-		plane->state->zpos = exynos_plane->config->zpos;
-	}
 }
 
 static struct drm_plane_state *
-- 
2.35.1