[PATCH v1 1/8] ARM: dts: imx6qdl-vicut1/vicutgo: Set default backlight brightness to maximum

[Oleksij Rempel]

From: David Jander <david at protonic.nl>

Recover default behavior of the device and set maximal brightness

Signed-off-by: David Jander <david at protonic.nl>
Signed-off-by: Oleksij Rempel <o.rempel at pengutronix.de>
---
 arch/arm/boot/dts/imx6dl-victgo.dts   | 2 +-
 arch/arm/boot/dts/imx6qdl-vicut1.dtsi | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/imx6dl-victgo.dts b/arch/arm/boot/dts/imx6dl-victgo.dts
index 227c952543d4..e6134efbfabd 100644
--- a/arch/arm/boot/dts/imx6dl-victgo.dts
+++ b/arch/arm/boot/dts/imx6dl-victgo.dts
@@ -28,7 +28,7 @@ backlight: backlight {
 		pwms = <&pwm1 0 5000000 0>;
 		brightness-levels = <0 16 64 255>;
 		num-interpolated-steps = <16>;
-		default-brightness-level = <1>;
+		default-brightness-level = <48>;
 		power-supply = <&reg_3v3>;
 		enable-gpios = <&gpio4 28 GPIO_ACTIVE_HIGH>;
 	};
diff --git a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
index 1ac7e13249d2..c1d06bc28c67 100644
--- a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
@@ -23,7 +23,7 @@ backlight: backlight {
 		pwms = <&pwm1 0 5000000 0>;
 		brightness-levels = <0 16 64 255>;
 		num-interpolated-steps = <16>;
-		default-brightness-level = <1>;
+		default-brightness-level = <48>;
 		power-supply = <&reg_3v3>;
 		enable-gpios = <&gpio4 28 GPIO_ACTIVE_HIGH>;
 	};
-- 
2.30.2