[PATCH v3 1/2] ARM: dts: imx6qp-sabresd: Enable PCIe support

[Shawn Guo]

On Tue, Feb 15, 2022 at 01:16:31PM +0800, Richard Zhu wrote:
> In the i.MX6QP sabresd board(sch-28857) design, one external oscillator
> is powered up by vgen3 and used as the PCIe reference clock source by
> the endpoint device.
> 
> If RC uses this oscillator as reference clock too, PLL6(ENET PLL) would
> has to be in bypass mode, and ENET clocks would be messed up.
> 
> To keep things simple, let RC use the internal PLL as reference clock
> and set vgen3 always on to enable the external oscillator for endpoint
> device on i.MX6QP sabresd board.
> 
> NOTE: This reference clock setup is used to pass the GEN2 TX compliance
> tests, and isn't recommended as a setup in the end-user design.
> 
> Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
> ---
>  arch/arm/boot/dts/imx6qp-sabresd.dts | 8 +++++++-
>  1 file changed, 7 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm/boot/dts/imx6qp-sabresd.dts b/arch/arm/boot/dts/imx6qp-sabresd.dts
> index 480e73183f6b..083cf90bcab5 100644
> --- a/arch/arm/boot/dts/imx6qp-sabresd.dts
> +++ b/arch/arm/boot/dts/imx6qp-sabresd.dts
> @@ -50,8 +50,14 @@ MX6QDL_PAD_SD3_DAT7__SD3_DATA7		0x17059
>  	};
>  };
>  
> +&vgen3_reg {
> +	regulator-min-microvolt = <1800000>;
> +	regulator-max-microvolt = <3300000>;

These can be saved, as they are unchanged?

Shawn

> +	regulator-always-on;
> +};
> +
>  &pcie {
> -	status = "disabled";
> +	status = "okay";
>  };
>  
>  &sata {
> -- 
> 2.25.1
>