[PATCH 2 4/9] serial: sc16is7xx: remove redundant check in rs485_config

[Lino Sanfilippo]

Hi,

On 17.02.22 at 12:47, Lukas Wunner wrote:
> On Wed, Feb 16, 2022 at 01:17:58AM +0100, Lino Sanfilippo wrote:
>> --- a/drivers/tty/serial/sc16is7xx.c
>> +++ b/drivers/tty/serial/sc16is7xx.c
>> @@ -959,16 +959,6 @@ static int sc16is7xx_config_rs485(struct uart_port *port,
>>  	struct sc16is7xx_one *one = to_sc16is7xx_one(port, port);
>>
>>  	if (rs485->flags & SER_RS485_ENABLED) {
>> -		bool rts_during_rx, rts_during_tx;
>> -
>> -		rts_during_rx = rs485->flags & SER_RS485_RTS_AFTER_SEND;
>> -		rts_during_tx = rs485->flags & SER_RS485_RTS_ON_SEND;
>> -
>> -		if (rts_during_rx == rts_during_tx)
>> -			dev_err(port->dev,
>> -				"unsupported RTS signalling on_send:%d after_send:%d - exactly one of RS485 RTS flags should be set\n",
>> -				rts_during_tx, rts_during_rx);
>> -
>
> Hm, patch 1 in this series doesn't emit such a message, so unlike now,
> users will no longer be warned that they passed in nonsensical settings...
>

what about logging a warning for both RTS polarity and delay correction?

Regards,
Lino