[PATCH v3 4/8] ARM: dts: bcm283x: fix ethernet node name

[Oleksij Rempel]

On Tue, Feb 15, 2022 at 01:01:06PM -0800, Florian Fainelli wrote:
> On 2/15/22 12:09 AM, Oleksij Rempel wrote:
> > It should be "ethernet at x" instead of "usbether at x"
> > 
> > Signed-off-by: Oleksij Rempel <o.rempel at pengutronix.de>
> 
> This looks like, a quick grep on the u-boot source code seems to suggest
> that only one file is assuming that 'usbether at 1' is to be used as a node
> name and the error message does not even match the code it is patching:
> 
> board/liebherr/xea/xea.c:
>   #ifdef CONFIG_OF_BOARD_SETUP
>   static int fdt_fixup_l2switch(void *blob)
>   {
>           u8 ethaddr[6];
>           int ret;
> 
>           if (eth_env_get_enetaddr("ethaddr", ethaddr)) {
>                   ret = fdt_find_and_setprop(blob,
> 
> "/ahb at 80080000/switch at 800f0000",
>                                              "local-mac-address",
> ethaddr, 6, 1);
>                   if (ret < 0)
>                           printf("%s: can't find usbether at 1 node: %d\n",
>                                  __func__, ret);
>           }

\o/ :)

>           return 0;
>   }
> 
> I will wait for the other maintainers on the other patches to provide
> some feedback, but if all is well, will apply this one soon.

Full path fdt matching has proven to be not stable enough. Especially on
chips with early DT adaptation like iMX. It is better to use aliases
where possible. 

Regards,
Oleksij
-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |