[PATCH 2 9/9] serial: atmel: remove redundant assignment in rs485_config

[Lino Sanfilippo]

In uart_set_rs485_config() the serial core already assigns the passed
serial_rs485 struct to the uart port.

So remove the assignment from the drivers rs485_config() function to avoid
redundancy.

Signed-off-by: Lino Sanfilippo <LinoSanfilippo at gmx.de>
---
 drivers/tty/serial/atmel_serial.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
index 2d09a89974a2..2ab589a3d86c 100644
--- a/drivers/tty/serial/atmel_serial.c
+++ b/drivers/tty/serial/atmel_serial.c
@@ -299,11 +299,9 @@ static int atmel_config_rs485(struct uart_port *port,
 	/* Resetting serial mode to RS232 (0x0) */
 	mode &= ~ATMEL_US_USMODE;
 
-	port->rs485 = *rs485conf;
-
 	if (rs485conf->flags & SER_RS485_ENABLED) {
 		dev_dbg(port->dev, "Setting UART to RS485\n");
-		if (port->rs485.flags & SER_RS485_RX_DURING_TX)
+		if (rs485conf->flags & SER_RS485_RX_DURING_TX)
 			atmel_port->tx_done_mask = ATMEL_US_TXRDY;
 		else
 			atmel_port->tx_done_mask = ATMEL_US_TXEMPTY;
-- 
2.34.1