[PATCH 2 3/9] serial: stm32: remove redundant code in rs485_config

[Lino Sanfilippo]

In uart_set_rs485_config() the serial core already ensures that only one of
both options RTS on send or RTS after send is set. It also assigns the
passed serial_rs485 struct to the uart port.

So remove the check and the assignment from the drivers rs485_config()
function to avoid redundancy.

Signed-off-by: Lino Sanfilippo <LinoSanfilippo at gmx.de>
---
 drivers/tty/serial/stm32-usart.c | 9 ++-------
 1 file changed, 2 insertions(+), 7 deletions(-)

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 1b3a611ac39e..6a014168102c 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -107,8 +107,6 @@ static int stm32_usart_config_rs485(struct uart_port *port,
 
 	stm32_usart_clr_bits(port, ofs->cr1, BIT(cfg->uart_enable_bit));
 
-	port->rs485 = *rs485conf;
-
 	rs485conf->flags |= SER_RS485_RX_DURING_TX;
 
 	if (rs485conf->flags & SER_RS485_ENABLED) {
@@ -128,13 +126,10 @@ static int stm32_usart_config_rs485(struct uart_port *port,
 					     rs485conf->delay_rts_after_send,
 					     baud);
 
-		if (rs485conf->flags & SER_RS485_RTS_ON_SEND) {
+		if (rs485conf->flags & SER_RS485_RTS_ON_SEND)
 			cr3 &= ~USART_CR3_DEP;
-			rs485conf->flags &= ~SER_RS485_RTS_AFTER_SEND;
-		} else {
+		else
 			cr3 |= USART_CR3_DEP;
-			rs485conf->flags |= SER_RS485_RTS_AFTER_SEND;
-		}
 
 		writel_relaxed(cr3, port->membase + ofs->cr3);
 		writel_relaxed(cr1, port->membase + ofs->cr1);
-- 
2.34.1