[PATCH 2 2/9] serial: amba-pl011: remove redundant code in rs485_config

[Lino Sanfilippo]

In uart_set_rs485_config() the serial core already

- ensures that only one of both options RTS on send or RTS after send is
  set

- nullifies the padding field of the passed serial_rs485 struct

- clamps the RTS delays

- assigns the passed serial_rs485 struct to the uart port

So remove these tasks from the code of the drivers rs485_config() function
to avoid redundancy.

Signed-off-by: Lino Sanfilippo <LinoSanfilippo at gmx.de>
---
 drivers/tty/serial/amba-pl011.c | 16 +---------------
 1 file changed, 1 insertion(+), 15 deletions(-)

diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
index ba053a68529f..35c633739975 100644
--- a/drivers/tty/serial/amba-pl011.c
+++ b/drivers/tty/serial/amba-pl011.c
@@ -2170,25 +2170,11 @@ static int pl011_rs485_config(struct uart_port *port,
 	struct uart_amba_port *uap =
 		container_of(port, struct uart_amba_port, port);
 
-	/* pick sane settings if the user hasn't */
-	if (!(rs485->flags & SER_RS485_RTS_ON_SEND) ==
-	    !(rs485->flags & SER_RS485_RTS_AFTER_SEND)) {
-		rs485->flags |= SER_RS485_RTS_ON_SEND;
-		rs485->flags &= ~SER_RS485_RTS_AFTER_SEND;
-	}
-	/* clamp the delays to [0, 100ms] */
-	rs485->delay_rts_before_send = min(rs485->delay_rts_before_send, 100U);
-	rs485->delay_rts_after_send = min(rs485->delay_rts_after_send, 100U);
-	memset(rs485->padding, 0, sizeof(rs485->padding));
-
 	if (port->rs485.flags & SER_RS485_ENABLED)
 		pl011_rs485_tx_stop(uap);
 
-	/* Set new configuration */
-	port->rs485 = *rs485;
-
 	/* Make sure auto RTS is disabled */
-	if (port->rs485.flags & SER_RS485_ENABLED) {
+	if (rs485->flags & SER_RS485_ENABLED) {
 		u32 cr = pl011_read(uap, REG_CR);
 
 		cr &= ~UART011_CR_RTSEN;
-- 
2.34.1