[PATCH v3 3/5] ARM: dts: imx6qdl-vicut1: add CAN termination support

[Shawn Guo]

On Fri, Feb 11, 2022 at 02:30:33PM +0100, Oleksij Rempel wrote:
> The gpio1 0 pin is controlling CAN termination, not USB H1 VBUS. So,
> remove wrong regulator and assign this gpio to new DT CAN termnation

Sigh, the typo is still there with a new version.

Fixed it up and applied the series.

Shawn

> property.
> 
> Signed-off-by: Oleksij Rempel <o.rempel at pengutronix.de>
> ---
>  arch/arm/boot/dts/imx6qdl-vicut1.dtsi | 12 ++----------
>  1 file changed, 2 insertions(+), 10 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
> index b9e305774fed..1ac7e13249d2 100644
> --- a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
> +++ b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
> @@ -126,15 +126,6 @@ reg_3v3: regulator-3v3 {
>  		regulator-max-microvolt = <3300000>;
>  	};
>  
> -	reg_h1_vbus: regulator-h1-vbus {
> -		compatible = "regulator-fixed";
> -		regulator-name = "h1-vbus";
> -		regulator-min-microvolt = <5000000>;
> -		regulator-max-microvolt = <5000000>;
> -		gpio = <&gpio1 0 GPIO_ACTIVE_HIGH>;
> -		enable-active-high;
> -	};
> -
>  	reg_otg_vbus: regulator-otg-vbus {
>  		compatible = "regulator-fixed";
>  		regulator-name = "otg-vbus";
> @@ -212,6 +203,8 @@ IMX_AUDMUX_V2_PTCR_SYN		IMX_AUDMUX_V2_PDCR_RXDSEL(0)
>  &can1 {
>  	pinctrl-names = "default";
>  	pinctrl-0 = <&pinctrl_can1>;
> +	termination-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>;
> +	termination-ohms = <150>;
>  	status = "okay";
>  };
>  
> @@ -492,7 +485,6 @@ &uart5 {
>  };
>  
>  &usbh1 {
> -	vbus-supply = <&reg_h1_vbus>;
>  	pinctrl-names = "default";
>  	phy_type = "utmi";
>  	dr_mode = "host";
> -- 
> 2.30.2
>