[PATCH v6 0/3] PCI: IPQ6018 platform support

[Baruch Siach]

This series adds support for the single PCIe lane on IPQ6018 SoCs. The code is 
ported from downstream Codeaurora v5.4 kernel. The main difference from 
downstream code is the split of PCIe registers configuration from .init to 
.post_init, since it requires phy_power_on().

Tested on IPQ6010 based hardware.

Changes in v6:

  * Drop DT patch applied to the qcom tree

  * Normalize driver changes subject line

  * Add a preparatory patch to rename PCIE_CAP_LINK1_VAL to PCIE_CAP_SLOT_VAL,
    and define it using PCI_EXP_SLTCAP_* macros

  * Drop a vague comment about ASPM configuration

  * Add a comment about the source of delay periods

Changes in v5:

  * Remove comments from qcom_pcie_init_2_9_0() (Bjorn Andersson)

Changes in v4:

  * Drop applied DT bits

  * Add max-link-speed that was missing from the applied v2 patch

  * Rebase the driver on v5.16-rc3

Changes in v3:

  * Drop applied patches

  * Rely on generic code for speed setup

  * Drop unused macros

  * Formatting fixes

Changes in v2:

  * Add patch moving GEN3_RELATED macros to a common header

  * Drop ATU configuration from pcie-qcom

  * Remove local definition of common registers

  * Use bulk clk and reset APIs

  * Remove msi-parent from device-tree

Baruch Siach (2):
  PCI: dwc: tegra: move GEN3_RELATED DBI register to common header
  PCI: qcom: Define slot capabilities using PCI_EXP_SLTCAP_*

Selvam Sathappan Periakaruppan (1):
  PCI: qcom: Add IPQ60xx support

 drivers/pci/controller/dwc/pcie-designware.h |   7 +
 drivers/pci/controller/dwc/pcie-qcom.c       | 155 ++++++++++++++++++-
 drivers/pci/controller/dwc/pcie-tegra194.c   |   6 -
 3 files changed, 160 insertions(+), 8 deletions(-)

-- 
2.34.1