[PATCH 1/2] arm64: dts: ti: k3-am65: disable optional peripherals by default

[Jan Kiszka]

On 02.02.22 21:32, Nishanth Menon wrote:
> On 12:25-20220111, Matthias Schiffer wrote:
>> All peripharals that require pinmuxing or other configuration to work
>> should be disabled by default. Dependent DTS are adjusted accordingly.
>>
>> The following nodes are now "disabled" according to dtx_diff and were not
>> overridden to "okay", as they define no pinctrl:
>>
>> k3-am654-base-board:
>> - mcu_i2c0
>> - mcu_spi0..2
>> - cal
>> - main_i2c3
>> - ehrpwm0..5
>> - main_uart1..2
>> - main_spi1..4
>>
>> k3-am65-iot2050*:
>> - mci_spi1..2
>> - cal
>> - ehrpwm0..5
>> - main_spi0..4
>>
>> Signed-off-by: Matthias Schiffer <matthias.schiffer at ew.tq-group.com>
> 
> 
> Jan: you ok with this series? Please ack.
> 

Just rebased the still-too-long backlog to our system fully working over 
mainline. Basically looks good, but this might be a regression of the 
patch:

[    1.810083] OF: /bus at 100000/pcie at 5600000: phandle pcie-mode at 4070 needs 1, found 0
...
[    1.854840] OF: /bus at 100000/pcie at 5600000: phandle pcie-devid at 210 needs 1, found 0

Jan

-- 
Siemens AG, Technology
Competence Center Embedded Linux