[PATCH 2/2] soc: s4: Add support for power domains controller

[Kevin Hilman]

Hi Shunzhou,

Shunzhou Jiang <shunzhou.jiang at amlogic.com> writes:

> Add support s4 Power controller. In s4, power control
> registers are in secure domain, and should be accessed by smc.
>
> Signed-off-by: Shunzhou Jiang <shunzhou.jiang at amlogic.com>

Thank you for adding support for S4 power domains.

> ---
>  drivers/soc/amlogic/meson-secure-pwrc.c | 21 +++++++++++++++++++++
>  1 file changed, 21 insertions(+)
>
> diff --git a/drivers/soc/amlogic/meson-secure-pwrc.c b/drivers/soc/amlogic/meson-secure-pwrc.c
> index 59bd195fa9c9..8fee01aabab6 100644
> --- a/drivers/soc/amlogic/meson-secure-pwrc.c
> +++ b/drivers/soc/amlogic/meson-secure-pwrc.c
> @@ -11,6 +11,7 @@
>  #include <linux/platform_device.h>
>  #include <linux/pm_domain.h>
>  #include <dt-bindings/power/meson-a1-power.h>
> +#include <dt-bindings/power/meson-s4-power.h>
>  #include <linux/arm-smccc.h>
>  #include <linux/firmware/meson/meson_sm.h>
>  #include <linux/module.h>
> @@ -119,6 +120,17 @@ static struct meson_secure_pwrc_domain_desc a1_pwrc_domains[] = {
>  	SEC_PD(RSA,	0),
>  };
>  
> +static struct meson_secure_pwrc_domain_desc s4_pwrc_domains[] = {
> +	SEC_PD(S4_DOS_HEVC,	0),
> +	SEC_PD(S4_DOS_VDEC,	0),
> +	SEC_PD(S4_VPU_HDMI,	GENPD_FLAG_ALWAYS_ON),
> +	SEC_PD(S4_USB_COMB,	GENPD_FLAG_ALWAYS_ON),
> +	SEC_PD(S4_GE2D,		0),
> +	SEC_PD(S4_ETH,		GENPD_FLAG_ALWAYS_ON),
> +	SEC_PD(S4_DEMOD,	0),
> +	SEC_PD(S4_AUDIO,	0),
> +};

We should avoid the GENPD_FLAG_ALWAYS_ON unless strictly necessary.  If
you look at a1_pwrc_domains[] in this same driver, any use of this flag
has a comment for why it's needed, and it's usually because the domain
is used by low-level SoC/PM code not controlled by linux.

All of these appear to be domains that linux should have driver control,
so should not be set to always on.

Kevin