[PATCH] gpio: Allow user to customise maximum number of GPIOs

[Davide Ciminaghi]

tl;dr: sta2x11 support can be removed.

On Sun, Aug 28, 2022 at 12:04:29PM +0200, Arnd Bergmann wrote:
> On Sun, Aug 28, 2022 at 11:06 AM Christophe Leroy
> <christophe.leroy at csgroup.eu> wrote:
> > Le 26/08/2022 ?? 23:54, Linus Walleij a ??crit :

....

>
> I think that just means the code that one would have to modify
> is in vendor kernels of devices using this chip, but there is no
> way to fix those if they are not in mainline. The last meaningful
> patches on this SoC support were in 2012 by  Davide Ciminaghi
> and Alessandro Rubini, though they still Acked patches after that.
> 
> I wonder if I was missing the interesting bit about it, if the driver
> is just obsolete and can be removed, or if there is something
> that is still worth fixing here.
>
Hi,

the sta2x11 was a chip containing AMBA peripherals and a PCIe to AMBA bridge
(it is still in production as far as I know, but deprecated for new designs).
It would typically be installed on x86 machines, so you needed to build and
run AMBA drivers in an x86 environment. The original drivers we started from
had platform data, but then we were told to switch to DTS.

Device trees, though, were not very common under x86 at the time and,
perhaps most important, we had a bunch of amba peripherals "behind" a
pci bus, which is a dynamic thing. Our idea was to build a device
tree at runtime (in user space) and then booting a second kernel via
kexec with the correct DTB, but this was not a complete solution.
For instance we needed to patch the device tree at runtime to
take dynamically assigned IRQ numbers into account.
Also the clocks tree had to be dynamically instantiated, once for each sta2x11
chip. Finally, there were some problems allocating dma buffers because
the AMBA side of the bridge could only reach some ranges of physical
addresses.

We had a more or less working prototype, and you may want to have a look
at some of our work:

https://lore.kernel.org/lkml/5202C655.6050609@zytor.com/t/

Nevertheless the upstreaming effort was eventually too big for Alessandro
and myself.
So the sta2x11 drivers upstreaming project has been abandoned (even though
I like to think of it as one of the funniest failures of my life).
Sta2x11 related drivers can of course be removed.


Thanks and regards
Davide