[RFC PATCH v2 3/4] ARM: dts: stm32: add pin map for CAN controller on stm32f4

[Dario Binacchi]

Hi Krzysztof,

On Tue, Aug 23, 2022 at 3:43 PM Krzysztof Kozlowski
<krzysztof.kozlowski at linaro.org> wrote:
>
> On 20/08/2022 11:29, Dario Binacchi wrote:
> > Add pin configurations for using CAN controller on stm32f469-disco
> > board. They are located on the Arduino compatible connector CN5 (CAN1)
> > and on the extension connector CN12 (CAN2).
> >
> > Signed-off-by: Dario Binacchi <dariobin at libero.it>
> > Signed-off-by: Dario Binacchi <dario.binacchi at amarulasolutions.com>
>
> Do not ignore review. This is not correct. You are mixing copyright with
> SoC...

OK. I got it. I will drop one SOB in version 3.

>
> >
>
>
> > +                     can2_pins_b: can2-1 {
> > +                             pins1 {
> > +                                     pinmux = <STM32_PINMUX('B', 13, AF9)>; /* CAN2_TX */
> > +                             };
> > +                             pins2 {
> > +                                     pinmux = <STM32_PINMUX('B', 12, AF9)>; /* CAN2_RX */
> > +                                     bias-pull-up;
> > +                             };
> > +                     };
> > +
>
> Don't ignore review.

Sorry, I didn't want to ignore your review, I thought the blank line
to be removed was another.
Actually I had to remove two blank lines and I left out the one you suggested.

Thanks and regards,
Dario

>
> That's second one, so that's a no.. :(


>
> Best regards,
> Krzysztof



-- 

Dario Binacchi

Embedded Linux Developer

dario.binacchi at amarulasolutions.com

__________________________________


Amarula Solutions SRL

Via Le Canevare 30, 31100 Treviso, Veneto, IT

T. +39 042 243 5310
info at amarulasolutions.com

www.amarulasolutions.com