[RFC PATCH 2/4] ARM: dts: stm32: add CAN support on stm32f429

[Dario Binacchi]

Add support for bxcan (Basic eXtended CAN controller) to STM32F429. The
chip contains two CAN peripherals, CAN1 the master and CAN2 the slave,
that share some of the required logic like clock and filters. This means
that the slave CAN can't be used without the master CAN.

Signed-off-by: Dario Binacchi <dariobin at libero.it>
Signed-off-by: Dario Binacchi <dario.binacchi at amarulasolutions.com>
---

 arch/arm/boot/dts/stm32f429.dtsi | 30 ++++++++++++++++++++++++++++++
 1 file changed, 30 insertions(+)

diff --git a/arch/arm/boot/dts/stm32f429.dtsi b/arch/arm/boot/dts/stm32f429.dtsi
index c31ceb821231..28db387ad5e8 100644
--- a/arch/arm/boot/dts/stm32f429.dtsi
+++ b/arch/arm/boot/dts/stm32f429.dtsi
@@ -362,6 +362,36 @@ i2c3: i2c at 40005c00 {
 			status = "disabled";
 		};
 
+		can: can at 40006400 {
+			compatible = "st,stm32-bxcan-core";
+			reg = <0x40006400 0x800>;
+			resets = <&rcc STM32F4_APB1_RESET(CAN1)>;
+			clocks = <&rcc 0 STM32F4_APB1_CLOCK(CAN1)>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			status = "disabled";
+
+			can1: can at 0 {
+				compatible = "st,stm32-bxcan";
+				reg = <0x0>;
+				interrupts = <19>, <20>, <21>, <22>;
+				interrupt-names = "tx", "rx0", "rx1", "sce";
+				resets = <&rcc STM32F4_APB1_RESET(CAN1)>;
+				master;
+				status = "disabled";
+			};
+
+			can2: can at 400 {
+				compatible = "st,stm32-bxcan";
+				reg = <0x400>;
+				interrupts = <63>, <64>, <65>, <66>;
+				interrupt-names = "tx", "rx0", "rx1", "sce";
+				resets = <&rcc STM32F4_APB1_RESET(CAN2)>;
+				clocks = <&rcc 0 STM32F4_APB1_CLOCK(CAN2)>;
+				status = "disabled";
+			};
+		};
+
 		dac: dac at 40007400 {
 			compatible = "st,stm32f4-dac-core";
 			reg = <0x40007400 0x400>;
-- 
2.32.0