[PATCH 1/3] dt-bindings: spi: stm32: Add st,dual-flash property in st,stm32-qspi.yaml

[Krzysztof Kozlowski]

On 09/08/2022 07:18, Krzysztof Kozlowski wrote:
> On 08/08/2022 19:08, Patrice CHOTARD wrote:
>> Hi Krzystof
>>
>> On 8/8/22 11:01, Krzysztof Kozlowski wrote:
>>> On 08/08/2022 10:40, patrice.chotard at foss.st.com wrote:
>>>> From: Patrice Chotard <patrice.chotard at foss.st.com>
>>>>
>>>> Add new property st,dual-flash which allows to use the QSPI interface as a
>>>> communication channel using up to 8 qspi line.
>>>> This mode can only be used if cs-gpios property is defined.
>>>>
>>>> Signed-off-by: Patrice Chotard <patrice.chotard at foss.st.com>
>>>> ---
>>>>  Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml | 8 ++++++++
>>>>  1 file changed, 8 insertions(+)
>>>>
>>>> diff --git a/Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml b/Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml
>>>> index 6ec6f556182f..5e4f9109799e 100644
>>>> --- a/Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml
>>>> +++ b/Documentation/devicetree/bindings/spi/st,stm32-qspi.yaml
>>>> @@ -46,6 +46,14 @@ properties:
>>>>        - const: tx
>>>>        - const: rx
>>>>  
>>>> +  st,dual-flash:
>>>> +    type: boolean
>>>> +    description:
>>>> +      Allows to use 8 data lines in case cs-gpios property is defined.
>>>
>>> It's named dual-flash, but what if you want to use QSPI to connect for
>>> example to FPGA?
>>>
>>> Also how is this related to parallel-memories property?
>>
>> I called it "dual-flash" simply because it enable the dual flash feature of the QSPI block (bit CR_DFM : Dual Flash Mode)
>> which allows to use the 8 lines simultaneously of our dual QSPI block.
> 
> And how is it related to existing parallel-memories property?

Maybe I was not specific enough, so let me rephrase - we have already
parallel-memories property. How this one is different (to justify the
new property)? Is just one memory connected in your case to QSPI over 8
data lines?

Best regards,
Krzysztof