[PATCH v2] arm64: dts: ti: k3-am64-mcu: remove incorrect UART base clock rates

[Vignesh Raghavendra]

Hi Matthias Schiffer,
 
On Tue, 19 Apr 2022 09:51:57 +0200, Matthias Schiffer wrote:
> We found that (at least some versions of) the sci-fw set the base clock
> rate for UARTs in the MCU domain to 96 MHz instead of the expected 48 MHz,
> leading to incorrect baud rates when used from Linux.
> 
> As the 8250_omap driver will query the actual clock rate from the clk
> driver when clock-frequency is unset, removing the incorrect property is
> sufficient to fix the baud rate.
> 
> [...]
 
I have applied the following to branch ti-k3-dts-next on [1].
Thank you!
 
[1/1] arm64: dts: ti: k3-am64-mcu: remove incorrect UART base clock rates
      commit: 439677d416b17dd39964d5f7d64b742a2e51da5b
 
All being well this means that it will be integrated into the linux-next
tree (usually sometime in the next 24 hours) and sent up the chain during
the next merge window (or sooner if it is a relevant bug fix), however if
problems are discovered then the patch may be dropped or reverted.
 
You may get further e-mails resulting from automated or manual testing
and review of the tree, please engage with people reporting problems and
send followup patches addressing any issues that are reported if needed.
 
If any updates are required or you are submitting further changes they
should be sent as incremental updates against current git, existing
patches will not be replaced.
 
Please add any relevant lists and maintainers to the CCs when replying
to this mail.
 
[1] https://git.kernel.org/pub/scm/linux/kernel/git/ti/linux.git
--
Vignesh