[PATCH 1/2] arm64: dts: imx8mm-beacon: Enable RTS-CTS on UART3

[Adam Ford]

There is a header for a DB9 serial port, but any attempts to use
hardware handshaking fail.  Enable RTS and CTS pin muxing and enable
handshaking in the uart node.

Signed-off-by: Adam Ford <aford173 at gmail.com>

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi
index ec3f2c177035..f338a886d811 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi
@@ -278,6 +278,7 @@ &uart3 {
 	pinctrl-0 = <&pinctrl_uart3>;
 	assigned-clocks = <&clk IMX8MM_CLK_UART3>;
 	assigned-clock-parents = <&clk IMX8MM_SYS_PLL1_80M>;
+	uart-has-rtscts;
 	status = "okay";
 };
 
@@ -386,6 +387,8 @@ pinctrl_uart3: uart3grp {
 		fsl,pins = <
 			MX8MM_IOMUXC_ECSPI1_SCLK_UART3_DCE_RX	0x40
 			MX8MM_IOMUXC_ECSPI1_MOSI_UART3_DCE_TX	0x40
+			MX8MM_IOMUXC_ECSPI1_MISO_UART3_DCE_CTS_B	0x40
+			MX8MM_IOMUXC_ECSPI1_SS0_UART3_DCE_RTS_B	0x40
 		>;
 	};
 
-- 
2.34.1