[PATCH 04/13] iommu/arm-smmu: Clean up bus_set_iommu()

[Will Deacon]

On Wed, Apr 20, 2022 at 05:05:03PM +0100, Robin Murphy wrote:
> On 2022-04-19 15:40, Will Deacon wrote:
> > On Thu, Apr 14, 2022 at 01:42:33PM +0100, Robin Murphy wrote:
> > > Stop calling bus_set_iommu() since it's now unnecessary. With device
> > > probes now replayed for every IOMMU instance registration, the whole
> > > sorry ordering workaround for legacy DT bindings goes too, hooray!
> > 
> > Ha, I hope you tested this!
> 
> Oh alright then, since it's you... :)
> 
> I've hacked up a Juno DT with the old bindings, and (after needing a while
> to remember that they're fundamentally incompatible with disable_bypass),
> can confirm that with my whole dev branch including this series applied, it
> boots and creates IOMMU groups as expected. I then made the mistake of
> trying without the branch to check whether the squawks from
> iommu_setup_dma_ops() were new or not, and... well... plain rc3 doesn't even
> boot on the same setup - it's somehow blowing up in the failure cleanup path
> of iommu_bus_init(), apparently calling iommu_release_device() on something
> where dev->iommu->iommu_dev is NULL, for reasons that are far from clear and
> I'm not sure I can really be bothered to debug further... :/

Great, so your series is a fix!

Will