[PATCH] ARM: dts: ux500: Add NFC to the Codina
Linus Walleij
linus.walleij at linaro.org
Thu Apr 14 13:10:22 PDT 2022
This adds the PN544 NFC chip mounted on some of the Codina models
numbered GT-I8160P. The "P" at the end of the product number
indicates that an NFC chip is mounted.
Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
---
.../arm/boot/dts/ste-ux500-samsung-codina.dts | 31 ++++++++++++++++++-
1 file changed, 30 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/ste-ux500-samsung-codina.dts b/arch/arm/boot/dts/ste-ux500-samsung-codina.dts
index e6ea63d23d26..3d8da98f16b2 100644
--- a/arch/arm/boot/dts/ste-ux500-samsung-codina.dts
+++ b/arch/arm/boot/dts/ste-ux500-samsung-codina.dts
@@ -307,7 +307,22 @@ i2c-gpio-1 {
#address-cells = <1>;
#size-cells = <0>;
- /* TODO: add the NFC chip here */
+ nfc at 2b {
+ /* NXP NFC circuit PN544 C1 marked NXP 44501 */
+ compatible = "nxp,pn544-i2c";
+ /* IF0, IF1 high, gives I2C address 0x2B */
+ reg = <0x2b>;
+ clock-frequency = <400000>;
+ /* NFC IRQ on GPIO32 */
+ interrupt-parent = <&gpio1>;
+ interrupts = <0 IRQ_TYPE_EDGE_FALLING>;
+ /* GPIO 31 */
+ firmware-gpios = <&gpio0 31 GPIO_ACTIVE_HIGH>;
+ /* GPIO88 */
+ enable-gpios = <&gpio2 24 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pn544_codina_default>;
+ };
};
spi-gpio-0 {
@@ -850,6 +865,20 @@ codina_cfg1 {
};
};
};
+ nfc {
+ pn544_codina_default: pn544_codina {
+ /* Interrupt line */
+ codina_cfg1 {
+ pins = "GPIO32_V2";
+ ste,config = <&gpio_in_nopull>;
+ };
+ /* Enable and firmware GPIOs */
+ codina_cfg2 {
+ pins = "GPIO31_V3", "GPIO88_C4";
+ ste,config = <&gpio_out_lo>;
+ };
+ };
+ };
vibrator {
vibrator_default: vibrator_default {
codina_cfg1 {
--
2.35.1
More information about the linux-arm-kernel
mailing list