[RFC 13/13] net: ti: icssg-prueth: Add ICSSG ethernet driver

[Puranjay Mohan]

+Roger, Grygorii

On 07/04/22 00:12, Andrew Lunn wrote:
>> +config TI_ICSSG_PRUETH
>> +	tristate "TI Gigabit PRU Ethernet driver"
>> +	select TI_DAVINCI_MDIO
>> +
> 
> I don't see a dependency on TI_DAVINCI_MDIO in the code. All you need
> is an MDIO bus so that your phy-handle has somewhere to point. But that
> could be a GPIO bit banger.
> 
> What i do think is missing here is a dependency on PHYLIB.
> 
> If possible, it would be good to also have it compile when
> COMPILE_TEST is set.
> 
>      Andrew