[PATCH 2/4] clocksource/drivers/timer-ti-dm: Update defines for am6 for inline functions

[Daniel Lezcano]

On 07/04/2022 10:15, Tony Lindgren wrote:
> * Daniel Lezcano <daniel.lezcano at linaro.org> [220407 08:01]:
>> On 07/04/2022 09:10, Tony Lindgren wrote:
>>> @@ -251,7 +251,8 @@ int omap_dm_timers_active(void);
>>>     * The below are inlined to optimize code size for system timers. Other code
>>>     * should not need these at all.
>>>     */
>>> -#if defined(CONFIG_ARCH_OMAP1) || defined(CONFIG_ARCH_OMAP2PLUS)
>>> +#if defined(CONFIG_ARCH_OMAP1) || defined(CONFIG_ARCH_OMAP2PLUS) || \
>>> +	defined(CONFIG_ARCH_K3)
>>
>> Why not replace the above by CONFIG_OMAP_DM_TIMER ?
> 
> Hmm that's a good question for why it was not that way earlier.
> 
> This series changes things for tristate "OMAP dual-mode timer driver" if
> ARCH_K3 || COMPILE_TEST though. So the inline stubs are still needed for
> COMPILE_TEST it seems.

But if ARCH_K3 or COMPILE_TEST is set, CONFIG_DM_TIMER is also set, no?


-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog