[PATCH] soc: imx: gpcv2: keep i.MX8MM VPU-H1 bus clock active

[Shawn Guo]

On Thu, Mar 31, 2022 at 06:32:13AM -0500, Adam Ford wrote:
> On Thu, Mar 31, 2022 at 4:28 AM Lucas Stach <l.stach at pengutronix.de> wrote:
> >
> > Hi Adam, hi Shawn,
> >
> > Am Samstag, dem 20.11.2021 um 13:39 -0600 schrieb Adam Ford:
> > > Enable the vpu-h1 clock when the domain is active because reading
> > > or writing to the VPU-H1 IP block cause the system to hang.
> > >
> > > Fixes: 656ade7aa42a ("soc: imx: gpcv2: keep i.MX8M* bus clocks enabled")
> > > Signed-off-by: Adam Ford <aford173 at gmail.com>
> > >
> > > diff --git a/drivers/soc/imx/gpcv2.c b/drivers/soc/imx/gpcv2.c
> > > index b8d52d8d29db..7b6dfa33dcb9 100644
> > > --- a/drivers/soc/imx/gpcv2.c
> > > +++ b/drivers/soc/imx/gpcv2.c
> > > @@ -734,6 +734,7 @@ static const struct imx_pgc_domain imx8mm_pgc_domains[] = {
> > >                       .map = IMX8MM_VPUH1_A53_DOMAIN,
> > >               },
> > >               .pgc   = BIT(IMX8MM_PGC_VPUH1),
> > > +             .keep_clocks = true,
> > >       },
> > >
> > I missed this patch and just stumbled across it when looking at the git
> > history. I don't think this patch is correct. The H1 GPC domain does
> > not even have clocks assigned in the DT, so there is nothing to keep
> > active. Also H1 is not a MIX domain, so it should not keep any bus
> > clocks active, that is the job of the VPUMIX domain.
> >
> > While this patch is a no-op, as far as I can see, it still seems wrong
> > and I think it should be reverted.
> 
> At the time I sent this, I was working with some people in the media
> group to split the G1 and G2 up in the imx8mq and add G1 and G2
> support in the imx8mm.  I had inquired about the feasibility of using
> the H1 encoder on the imx8mm, but I needed to read some registers from
> the IP block to see which features were fused out.  I tried several
> different options to get the H1 to not hang when reading registers,
> and that was the only solution I found that worked.  I thought it odd
> as well since the G1 and G2 decoders didn't appear to need this.
> However, during the course of my investigation, I learned that the
> JPEG encoder was fused out of the imx8mm, and there wasn't a plan to
> add VP8 or H.264 encodering any time soon.   Since it is, as you put
> it, a no-op, I have no objections to reverting it.

I do not quite follow.  You claimed that the change fixes a system hang.
Are we getting the hang back if we revert the change?

Shawn