[PATCH v2 24/43] KVM: VMX: Drop pointless PI.NDST update when blocking

[Maxim Levitsky]

On Fri, 2021-10-08 at 19:12 -0700, Sean Christopherson wrote:
> Don't update Posted Interrupt's NDST, a.k.a. the target pCPU, in the
> pre-block path, as NDST is guaranteed to be up-to-date.  The comment
> about the vCPU being preempted during the update is simply wrong, as the
> update path runs with IRQs disabled (from before snapshotting vcpu->cpu,
> until after the update completes).
> 
> The vCPU can get preempted _before_ the update starts, but not during.
> And if the vCPU is preempted before, vmx_vcpu_pi_load() is responsible
> for updating NDST when the vCPU is scheduled back in.  In that case, the
> check against the wakeup vector in vmx_vcpu_pi_load() cannot be true as
> that would require the notification vector to have been set to the wakeup
> vector _before_ blocking.
> 
> Opportunistically switch to using vcpu->cpu for the list/lock lookups,
> which presumably used pre_pcpu only for some phantom preemption logic.
> 
> Signed-off-by: Sean Christopherson <seanjc at google.com>
> ---
>  arch/x86/kvm/vmx/posted_intr.c | 23 +++--------------------
>  1 file changed, 3 insertions(+), 20 deletions(-)
> 
> diff --git a/arch/x86/kvm/vmx/posted_intr.c b/arch/x86/kvm/vmx/posted_intr.c
> index 1688f8dc535a..239e0e72a0dd 100644
> --- a/arch/x86/kvm/vmx/posted_intr.c
> +++ b/arch/x86/kvm/vmx/posted_intr.c
> @@ -130,7 +130,6 @@ static void __pi_post_block(struct kvm_vcpu *vcpu)
>   * - Store the vCPU to the wakeup list, so when interrupts happen
>   *   we can find the right vCPU to wake up.
>   * - Change the Posted-interrupt descriptor as below:
> - *      'NDST' <-- vcpu->pre_pcpu
>   *      'NV' <-- POSTED_INTR_WAKEUP_VECTOR
>   * - If 'ON' is set during this process, which means at least one
>   *   interrupt is posted for this vCPU, we cannot block it, in
> @@ -139,7 +138,6 @@ static void __pi_post_block(struct kvm_vcpu *vcpu)
>   */
>  int pi_pre_block(struct kvm_vcpu *vcpu)
>  {
> -	unsigned int dest;
>  	struct pi_desc old, new;
>  	struct pi_desc *pi_desc = vcpu_to_pi_desc(vcpu);
>  
> @@ -153,10 +151,10 @@ int pi_pre_block(struct kvm_vcpu *vcpu)
>  	local_irq_disable();
>  
>  	vcpu->pre_pcpu = vcpu->cpu;
> -	spin_lock(&per_cpu(blocked_vcpu_on_cpu_lock, vcpu->pre_pcpu));
> +	spin_lock(&per_cpu(blocked_vcpu_on_cpu_lock, vcpu->cpu));
>  	list_add_tail(&vcpu->blocked_vcpu_list,
> -		      &per_cpu(blocked_vcpu_on_cpu, vcpu->pre_pcpu));
> -	spin_unlock(&per_cpu(blocked_vcpu_on_cpu_lock, vcpu->pre_pcpu));
> +		      &per_cpu(blocked_vcpu_on_cpu, vcpu->cpu));
> +	spin_unlock(&per_cpu(blocked_vcpu_on_cpu_lock, vcpu->cpu));
>  
>  	WARN(pi_desc->sn == 1,
>  	     "Posted Interrupt Suppress Notification set before blocking");
> @@ -164,21 +162,6 @@ int pi_pre_block(struct kvm_vcpu *vcpu)
>  	do {
>  		old.control = new.control = pi_desc->control;
>  
> -		/*
> -		 * Since vCPU can be preempted during this process,
> -		 * vcpu->cpu could be different with pre_pcpu, we
> -		 * need to set pre_pcpu as the destination of wakeup
> -		 * notification event, then we can find the right vCPU
> -		 * to wakeup in wakeup handler if interrupts happen
> -		 * when the vCPU is in blocked state.
> -		 */
> -		dest = cpu_physical_id(vcpu->pre_pcpu);
> -
> -		if (x2apic_mode)
> -			new.ndst = dest;
> -		else
> -			new.ndst = (dest << 8) & 0xFF00;
> -
>  		/* set 'NV' to 'wakeup vector' */
>  		new.nv = POSTED_INTR_WAKEUP_VECTOR;
>  	} while (cmpxchg64(&pi_desc->control, old.control,
Reviewed-by : Maxim Levitsky <mlevitsk at redhat.com>

Best regards,
	Maxim Levitsky