[PATCH v5 1/7] dt-bindings: mediatek,dpi: Add DP_INTF compatible

[Markus Schneider-Pargmann]

DP_INTF is similar to DPI but does not have the exact same feature set
or register layouts.

DP_INTF is the sink of the display pipeline that is connected to the
DisplayPort controller and encoder unit. It takes the same clocks as
DPI.

Signed-off-by: Markus Schneider-Pargmann <msp at baylibre.com>
---

Notes:
    Changes v4 -> v5:
    - Newly created patch after realizing that the specific clocks for dpintf were
      the same as engine and pixel clocks.

 .../bindings/display/mediatek/mediatek,dpi.yaml       | 11 ++++++-----
 1 file changed, 6 insertions(+), 5 deletions(-)

diff --git a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.yaml b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.yaml
index dd2896a40ff0..53acf9a84f7f 100644
--- a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.yaml
+++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.yaml
@@ -4,16 +4,16 @@
 $id: http://devicetree.org/schemas/display/mediatek/mediatek,dpi.yaml#
 $schema: http://devicetree.org/meta-schemas/core.yaml#
 
-title: mediatek DPI Controller Device Tree Bindings
+title: mediatek DPI/DP_INTF Controller Device Tree Bindings
 
 maintainers:
   - CK Hu <ck.hu at mediatek.com>
   - Jitao shi <jitao.shi at mediatek.com>
 
 description: |
-  The Mediatek DPI function block is a sink of the display subsystem and
-  provides 8-bit RGB/YUV444 or 8/10/10-bit YUV422 pixel data on a parallel
-  output bus.
+  The Mediatek DPI and DP_INTF function blocks are a sink of the display
+  subsystem and provides 8-bit RGB/YUV444 or 8/10/10-bit YUV422 pixel data on a
+  parallel output bus.
 
 properties:
   compatible:
@@ -23,6 +23,7 @@ properties:
       - mediatek,mt8173-dpi
       - mediatek,mt8183-dpi
       - mediatek,mt8192-dpi
+      - mediatek,mt8195-dpintf
 
   reg:
     maxItems: 1
@@ -54,7 +55,7 @@ properties:
     $ref: /schemas/graph.yaml#/properties/port
     description:
       Output port node. This port should be connected to the input port of an
-      attached HDMI or LVDS encoder chip.
+      attached HDMI, LVDS or DisplayPort encoder chip.
 
 required:
   - compatible
-- 
2.33.0