[PATCH V2 linux-pinctrl 1/2] Revert "dt-bindings: pinctrl: bcm4708-pinmux: rework binding to use syscon"

[Rob Herring]

On Fri, 08 Oct 2021 17:39:38 +0200, Rafał Miłecki wrote:
> From: Rafał Miłecki <rafal at milecki.pl>
> 
> This reverts commit 2ae80900f239484069569380e1fc4340fd6e0089.
> 
> My rework was unneeded & wrong. It replaced a clear & correct "reg"
> property usage with a custom "offset" one.
> 
> Back then I didn't understand how to properly handle CRU block binding.
> I heard / read about syscon and tried to use it in a totally invalid
> way. That change also missed Rob's review (obviously).
> 
> Northstar's pin controller is a simple consistent hardware block that
> can be cleanly mapped using a 0x24 long reg space.
> 
> Since the rework commit there wasn't any follow up modifying in-kernel
> DTS files to use the new binding. Broadcom also isn't known to use that
> bugged binding. There is close to zero chance this revert may actually
> cause problems / regressions.
> 
> This commit is a simple revert. Example binding may (should) be updated
> / cleaned up but that can be handled separately.
> 
> Signed-off-by: Rafał Miłecki <rafal at milecki.pl>
> ---
> V2: Update brcm,cru.yaml to avoid new yamllint warnings/errors
> ---
>  .../devicetree/bindings/mfd/brcm,cru.yaml     | 11 +++++----
>  .../bindings/pinctrl/brcm,ns-pinmux.yaml      | 23 +++++++++++--------
>  2 files changed, 19 insertions(+), 15 deletions(-)
> 

My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/pinctrl/brcm,ns-pinmux.example.dt.yaml: cru at 1800c100: $nodename:0: 'cru at 1800c100' does not match '^([a-z][a-z0-9\\-]+-bus|bus|soc|axi|ahb|apb)(@[0-9a-f]+)?$'
	From schema: /usr/local/lib/python3.8/dist-packages/dtschema/schemas/simple-bus.yaml

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/patch/1538413

This check can fail if there are any dependencies. The base for a patch
series is generally the most recent rc1.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit.