[PATCH linux-pinctrl 1/2] Revert "dt-bindings: pinctrl: bcm4708-pinmux: rework binding to use syscon"

[Rafał Miłecki]

From: Rafał Miłecki <rafal at milecki.pl>

This reverts commit 2ae80900f239484069569380e1fc4340fd6e0089.

My rework was unneeded & wrong. It replaced a clear & correct "reg"
property usage with a custom "offset" one.

Back then I didn't understand how to properly handle CRU block binding.
I heard / read about syscon and tried to use it in a totally invalid
way. That change also missed Rob's review (obviously).

Northstar's pin controller is a simple consistent hardware block that
can be cleanly mapped using a 0x24 long reg space.

Since the rework commit there wasn't any follow up modifying in-kernel
DTS files to use the new binding. Broadcom also isn't known to use that
bugged binding. There is close to zero chance this revert may actually
cause problems / regressions.

This commit is a simple revert. Example binding may (should) be updated
/ cleaned up but that can be handled separately.

Signed-off-by: Rafał Miłecki <rafal at milecki.pl>
---
 .../bindings/pinctrl/brcm,ns-pinmux.yaml      | 23 +++++++++++--------
 1 file changed, 13 insertions(+), 10 deletions(-)

diff --git a/Documentation/devicetree/bindings/pinctrl/brcm,ns-pinmux.yaml b/Documentation/devicetree/bindings/pinctrl/brcm,ns-pinmux.yaml
index 470aff599c27..78600a8fe403 100644
--- a/Documentation/devicetree/bindings/pinctrl/brcm,ns-pinmux.yaml
+++ b/Documentation/devicetree/bindings/pinctrl/brcm,ns-pinmux.yaml
@@ -17,9 +17,6 @@ description:
 
   A list of pins varies across chipsets so few bindings are available.
 
-  Node of the pinmux must be nested in the CRU (Central Resource Unit) "syscon"
-  node.
-
 properties:
   compatible:
     enum:
@@ -27,10 +24,11 @@ properties:
       - brcm,bcm4709-pinmux
       - brcm,bcm53012-pinmux
 
-  offset:
-    description: offset of pin registers in the CRU block
+  reg:
     maxItems: 1
-    $ref: /schemas/types.yaml#/definitions/uint32-array
+
+  reg-names:
+    const: cru_gpio_control
 
 patternProperties:
   '-pins$':
@@ -72,19 +70,24 @@ allOf:
                         uart1_grp ]
 
 required:
-  - offset
+  - reg
+  - reg-names
 
 additionalProperties: false
 
 examples:
   - |
     cru at 1800c100 {
-        compatible = "syscon", "simple-mfd";
+        compatible = "simple-bus";
         reg = <0x1800c100 0x1a4>;
+        ranges;
+        #address-cells = <1>;
+        #size-cells = <1>;
 
-        pinctrl {
+        pin-controller at 1c0 {
             compatible = "brcm,bcm4708-pinmux";
-            offset = <0xc0>;
+            reg = <0x1c0 0x24>;
+            reg-names = "cru_gpio_control";
 
             spi-pins {
                 function = "spi";
-- 
2.26.2