[PATCH 4/6] dt-bindings: clock: Add bindings definitions for Exynos850 CMU

[Sam Protsenko]

On Wed, 6 Oct 2021 at 13:49, Krzysztof Kozlowski
<krzysztof.kozlowski at canonical.com> wrote:
>
> On 05/10/2021 12:28, Sam Protsenko wrote:
> > On Wed, 15 Sept 2021 at 19:37, Chanwoo Choi <cwchoi00 at gmail.com> wrote:
> >>
> >> Hi,
> >>
> >> You don't add clock ids for the all defined clocks in clk-exynos850.c.
> >> I recommend that add all clock ids for the defined clocks if possible.
> >>
> >> If you want to change the parent clock of mux or change the clock rate
> >> of div rate for some clocks, you have to touch the files as following:
> >> - include/dt-bindings/clock/exynos850.h
> >> - drivers/clk/samsung/clk-exynos850.c
> >> - exynos850 dt files
> >>
> >> If you define the clock ids for all clocks added to this patchset,
> >> you can change the parent or rate by just editing the dt files.
> >>
> >
> > Hi Chanwoo,
> >
> > I see your point. But I have intentionally omitted some clock ids,
> > which can't be / shouldn't be used by consumers in device tree.
> > Actually I took that idea from clk-exynos7.c.
> >
> > Krzysztof, Sylwester: can you please advice if all clock ids should be
> > defined, or only those that are going to be used in dts clk consumers?
> > I don't mind reworking the patch, just want to be sure which design
> > approach we want to follow.
> >
>
> I would advise to define all clock IDs, unless the clock really, really
> should not be used. Why do you think several clocks should not be used?
> Have in mind it is not only about consumers but also clock reparenting
> and assigning rates.
>

Thanks! Will be done in v2.

>
> Best regards,
> Krzysztof