[PATCH 2/8] arm64: dts: imx8mm-kontron: Make sure SOC and DRAM supply voltages are correct

[Frieder Schrempf]

On 05.10.21 08:53, Shawn Guo wrote:
> On Thu, Sep 30, 2021 at 05:56:25PM +0200, Frieder Schrempf wrote:
>> From: Frieder Schrempf <frieder.schrempf at kontron.de>
>>
>> VDD_SOC should be 800 mV in suspend and 850 mV in run mode. VDD_DRAM
>> should be 950 mV for DDR clock frequencies of 1.5 GHz.
>>
>> This information is taken from the datasheet and the uboot-imx code.
> 
> I'm wondering where the existing settings were coming from?

Good question, but I can't really retrace now how I actually determined
the values back then. Seems like I had failed to validate them properly.

> 
>>
>> Signed-off-by: Frieder Schrempf <frieder.schrempf at kontron.de>
>> ---
>>  arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi | 6 ++++--
>>  1 file changed, 4 insertions(+), 2 deletions(-)
>>
>> diff --git a/arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi
>> index 03b3516abd64..b12fb7ce6686 100644
>> --- a/arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi
>> +++ b/arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi
>> @@ -92,10 +92,12 @@ regulators {
>>  			reg_vdd_soc: BUCK1 {
>>  				regulator-name = "buck1";
>>  				regulator-min-microvolt = <800000>;
>> -				regulator-max-microvolt = <900000>;
>> +				regulator-max-microvolt = <850000>;
>>  				regulator-boot-on;
>>  				regulator-always-on;
>>  				regulator-ramp-delay = <3125>;
>> +				nxp,dvs-run-voltage = <850000>;
>> +				nxp,dvs-standby-voltage = <800000>;
>>  			};
>>  
>>  			reg_vdd_arm: BUCK2 {
>> @@ -111,7 +113,7 @@ reg_vdd_arm: BUCK2 {
>>  			reg_vdd_dram: BUCK3 {
>>  				regulator-name = "buck3";
>>  				regulator-min-microvolt = <850000>;
>> -				regulator-max-microvolt = <900000>;
>> +				regulator-max-microvolt = <950000>;
>>  				regulator-boot-on;
>>  				regulator-always-on;
>>  			};
>> -- 
>> 2.33.0
>>