[PATCH v2 0/8] Arm boards syscon 'unit_address_format' clean-ups

[Rob Herring]

On Mon, Sep 13, 2021 at 02:28:08PM -0500, Rob Herring wrote:
> This series addresses the last of the dtc 'unit_address_format'
> warnings in the tree.
> 
> The remaining issue was dealing with the node names on 2 bindings for
> Arm Ltd boards syscon child nodes: register-bit-led and Versatile ICST.
> Both of these used an offset property for register address rather than
> 'reg' which is the preference nowadays. With a 'reg' property, then we
> can have a proper node name and unit-address. This series adds support
> for using 'reg' instead and updates the node names and unit-addresses.
> 
> The dts file changes have inter-dependencies, but the clock and led
> changes can go via each subsystem.
> 
> Rob
> 
> 
> Rob Herring (8):
>   dt-bindings: leds: Convert register-bit-led binding to DT schema
>   dt-bindings: leds: register-bit-led: Use 'reg' instead of 'offset'
>   leds: syscon: Support 'reg' in addition to 'offset' for register
>     address

Pavel, Can you apply or comment on patches 1-3?

Rob


>   dt-bindings: clock: arm,syscon-icst: Use 'reg' instead of 'vco-offset'
>     for VCO register address
>   clk: versatile: clk-icst: Support 'reg' in addition to 'vco-offset'
>     for register address
>   ARM: dts: arm: Update register-bit-led nodes 'reg' and node names
>   ARM: dts: arm: Update ICST clock nodes 'reg' and node names
>   kbuild: Enable dtc 'unit_address_format' warning by default