[PATCH v2 4/4] perf arm-spe: Support hardware-based PID tracing

[Leo Yan]

On Wed, Nov 10, 2021 at 11:28:48PM -0800, Namhyung Kim wrote:

[...]

> > +static void arm_spe_set_pid_tid_cpu(struct arm_spe *spe,
> > +                                   struct auxtrace_queue *queue)
> > +{
> > +       struct arm_spe_queue *speq = queue->priv;
> > +       pid_t tid;
> > +
> > +       tid = machine__get_current_tid(spe->machine, speq->cpu);
> > +       if (tid != -1) {
> > +               speq->tid = tid;
> > +               thread__zput(speq->thread);
> > +       } else
> > +               speq->tid = queue->tid;
> > +
> > +       if ((!speq->thread) && (speq->tid != -1)) {
> > +               speq->thread = machine__find_thread(spe->machine, -1,
> > +                                                   speq->tid);
> > +       }
> > +
> > +       if (speq->thread) {
> > +               speq->pid = speq->thread->pid_;
> > +               if (queue->cpu == -1)
> > +                       speq->cpu = speq->thread->cpu;
> > +       }
> > +}
> > +
> > +static int arm_spe_set_tid(struct arm_spe_queue *speq, pid_t tid)
> > +{
> > +       struct arm_spe *spe = speq->spe;
> > +       int err = machine__set_current_tid(spe->machine, speq->cpu, tid, tid);
> 
> I think we should pass -1 as pid as we don't know the real pid.

AFAICT, I observe one case for machine__set_current_tid() returning error
is 'speq->cpu' is -1 (this is the case for per-thread tracing).  In
this case, if pass '-1' for pid/tid, it still will return failure.

So here should return the error as it is.  Am I missing anything?

Thanks,
Leo