[PATCH v2 07/13] clk: imx: Add initial support for i.MXRT clock driver
Jesse Taube
mr.bossman075 at gmail.com
Tue Nov 2 16:38:02 PDT 2021
On 11/2/21 19:34, Fabio Estevam wrote:
> On Tue, Nov 2, 2021 at 7:57 PM Jesse Taube <mr.bossman075 at gmail.com> wrote:
>
>> +#include "clk.h"
This is necessary for the indices.
>> +#define ANATOP_BASE_ADDR 0x400d8000
OOPs my bad will fix.
>
> This is now unused. Please remove it.
>
>> + clk[IMXRT1050_CLK_USDHC1] = imx_clk_gate2("usdhc1", "usdhc1_podf", ccm_base + 0x80, 2);
>> + clk[IMXRT1050_CLK_USDHC2] = imx_clk_gate2("usdhc2", "usdhc2_podf", ccm_base + 0x80, 4);
>> + clk[IMXRT1050_CLK_LPUART1] = imx_clk_gate2("lpuart1", "lpuart_podf", ccm_base + 0x7c, 24);
>> + clk[IMXRT1050_CLK_LCDIF_APB] = imx_clk_gate2("lcdif", "lcdif_podf", ccm_base + 0x74, 10);
>> + clk[IMXRT1050_CLK_DMA] = imx_clk_gate("dma", "ipg", ccm_base + 0x7C, 6);
>> + clk[IMXRT1050_CLK_DMA_MUX] = imx_clk_gate("dmamux0", "ipg", ccm_base + 0x7C, 7);
>
> The imx clock drivers have been converted to the clk_hw API.
>
Oh will do, didn't know this.
> For a reference, please check:
> f1541e15e38e ("clk: imx6sx: Switch to clk_hw based API")
>
> The same conversion could be done here.
>
>> + imx_check_clocks(clk, ARRAY_SIZE(clk));
>> + clk_data.clks = clk;
>> + clk_data.clk_num = ARRAY_SIZE(clk);
>> + of_clk_add_provider(np, of_clk_src_onecell_get, &clk_data);
>> + clk_prepare_enable(clk[IMXRT1050_CLK_PLL1_ARM]);
>> + clk_prepare_enable(clk[IMXRT1050_CLK_PLL2_SYS]);
>> + clk_prepare_enable(clk[IMXRT1050_CLK_PLL3_USB_OTG]);
>> + clk_prepare_enable(clk[IMXRT1050_CLK_PLL3_PFD1_664_62M]);
>> + clk_prepare_enable(clk[IMXRT1050_CLK_PLL2_PFD2_396M]);
>
> If these clocks are essential for the SoC to work, then you could pass
> the CLK_IS_CRITICAL flag instead of calling clk_prepare_enable()
>
I'll look into that Thx
More information about the linux-arm-kernel
mailing list