[PATCH 2/3] dmaengine: usb-dmac: Fix PM reference leak in usb_dmac_probe()

[Vinod Koul]

On 31-05-21, 14:11, yukuai (C) wrote:
> On 2021/05/31 12:00, Vinod Koul wrote:
> > On 17-05-21, 16:18, Yu Kuai wrote:
> > > pm_runtime_get_sync will increment pm usage counter even it failed.
> > > Forgetting to putting operation will result in reference leak here.
> > > Fix it by replacing it with pm_runtime_resume_and_get to keep usage
> > > counter balanced.
> > > 
> > > Reported-by: Hulk Robot <hulkci at huawei.com>
> > > Signed-off-by: Yu Kuai <yukuai3 at huawei.com>
> > > ---
> > >   drivers/dma/sh/usb-dmac.c | 2 +-
> > >   1 file changed, 1 insertion(+), 1 deletion(-)
> > > 
> > > diff --git a/drivers/dma/sh/usb-dmac.c b/drivers/dma/sh/usb-dmac.c
> > > index 8f7ceb698226..2a6c8fd8854e 100644
> > > --- a/drivers/dma/sh/usb-dmac.c
> > > +++ b/drivers/dma/sh/usb-dmac.c
> > > @@ -796,7 +796,7 @@ static int usb_dmac_probe(struct platform_device *pdev)
> > >   	/* Enable runtime PM and initialize the device. */
> > >   	pm_runtime_enable(&pdev->dev);
> > > -	ret = pm_runtime_get_sync(&pdev->dev);
> > > +	ret = pm_runtime_resume_and_get(&pdev->dev);
> > 
> > This does not seem to fix anything.. the below goto goes and disables
> > the runtime_pm for this device and thus there wont be any leak
> Hi,
> 
> If pm_runtime_get_sync() fails and increments the pm.usage_count
> variable, pm_runtime_disable() does not reset the counter, and
> we still need to decrement the usage count when pm_runtime_get_sync()
> fails. Do I miss anthing?

Yes the rumtime_pm is disabled on failure here and the count would have
no consequence...

-- 
~Vinod